| Description | Taq MasterMix is a premixed system composed of Taq DNA Polymerase, Mg2+, dNTPs, as well as PCR stabilizers and enhancers, with a concentration of 2 ×. The pre prepared PCR mixture makes the operation simpler and faster, and can minimize human error and contamination to the greatest extent Taq MasterMix is a premixed system composed of Taq DNA Polymerase, Mg2+, dNTPs, as well as PCR stabilizers and enhancers, with a concentration of 2 ×. The pre prepared PCR mixture makes the operation simpler and faster, and can minimize human error and contamination to the greatest extent possible. The original MasterMix formula results in high yield, strong repeatability, and good stability of amplified products. This product has been added with a dye (blue), and can be directly subjected to electrophoresis detection after the reaction is completed. The amplified PCR product has an "A" base attached to its 3 'end, making it suitable for direct use in T/A cloning. Mainly suitable for PCR amplification of DNA, DNA sequencing and other experiments. T665590Component5 mL25 mLStorageT665590A2×Taq MasterMix (Dye)5×1 mL5×5 mL-20℃. Avoid freeze/thaw cycle.T665590BddH₂O5×1 mL5×5 mL-20℃. Avoid freeze/thaw cycle.2×Taq MasterMix contains Taq DNA Polymerase, 3 mM Mg Cl₂ and 400 µM each dNTP. Quality control:After testing, there was no exogenous nuclease activity; PCR method for detecting residual DNA without host; Can effectively amplify single copy genes from multiple genomes.Usage:The following is an example of a PCR reaction system and reaction conditions for amplifying a 1 kb fragment using human genomic DNA as a template. In practical operation, corresponding improvements and optimizations should be made based on the template, primer structure, and target fragment size.1. PCR reaction system Reagent 50 µlReaction system Final concentration 2×Taq MasterMix（Dye） 25 µL 1× Forward Primer，10 µM 2 µL 0.4 µM Reverse Primer，10 µM 2 µl 0.4 µM Template DNA <0.5 µg <0.5 µg/50 µL ddH2O up to 50 µL /Attention: The primer concentration should be between 0.1 and 1.0 as the final concentration µ M serves as a reference for setting the range. In the case of low amplification efficiency, the concentration of primers can be increased; When non-specific reactions occur, the primer concentration can be reduced to optimize the reaction system.2. PCR reaction conditions Step Temperature Time / Pre denaturation 94℃ 2 min / Denaturation 94℃ 30 s 25-35 cycles Anneal 55-65℃ 30 s 25-35 cycles Extend 72℃ 30 s 25-35 cycles Finally extended 72℃ 2 min / Attention:1) In general experiments, if the annealing temperature is 5 ° C lower than the melting temperature Tm of the amplification primer, and the ideal amplification efficiency cannot be achieved, the annealing temperature should be appropriately reduced; When non-specific reactions occur, increase the annealing temperature to optimize the reaction conditions.2) The extension time should be set according to the size of the amplified fragment. The amplification efficiency of Taq DNA Polymerase in this product is 2 kb/min.3) The number of cycles can be set based on the downstream application of the amplification product. If the number of cycles is too small, the amplification amount is insufficient; If there are too many cycles, the probability of mismatches will increase, and non-specific backgrounds will be severe. So, while ensuring product yield, the number of cycles should be minimized as much as possible... Read More | Inquire | HIV-1 Tat Protein Peptide is a synthetic peptide that includes the sequence responsible for the cellular uptake of the human immunodeficiency virus-1 Tat protein, consisting of the polycationic region 49-57. The peptide is part of the protein transduction domain (PTD) and was shown to enable the HIV-1 Tat Protein Peptide is a synthetic peptide that includes the sequence responsible for the cellular uptake of the human immunodeficiency virus-1 Tat protein, consisting of the polycationic region 49-57. The peptide is part of the protein transduction domain (PTD) and was shown to enable the introduction of nucleic acids into cells... Read More | Purity:>95%, by SDS-PAGE visualized with Coomassie® Blue Staining.Description： Cyclin-Dependent Kinase Inhibitor 1B (CDKN1B) is a Kinesin-related motor protein necessary for mitotic spindle assembly and chromosome segregation. CDKN1B is expressed in all tissues with highest levels Purity:>95%, by SDS-PAGE visualized with Coomassie® Blue Staining.Description： Cyclin-Dependent Kinase Inhibitor 1B (CDKN1B) is a Kinesin-related motor protein necessary for mitotic spindle assembly and chromosome segregation. CDKN1B is expressed in all tissues with highest levels observed in skeletal muscle. CDKN1B is a potent inhibitor of Cyclin E- and Cyclin A-CDK2 complexes. CDKN1B forms a complex with Cyclin Type D-CDK4 complexes and is involved in the assembly, stability, and modulation of CCND1-CDK4 complex activation. In addition, CDKN1B acts as an inhibitor or an activator of Cyclin Type D-CDK4 complexes depending on its phosphorylation state and stoichometry... Read More | The recombinant Protein A is a genetically engineering protein containing IgG-binding domains.Recombinant Protein A is ideal for purification of polyclonal or monoclonal IgG antibodies. Protein A binds to most human and mouse IgG subclasses (e.g., human IgG1, IgG2, IgG4; mouse IgG2, IgG2a, IgG2b,The recombinant Protein A is a genetically engineering protein containing IgG-binding domains.Recombinant Protein A is ideal for purification of polyclonal or monoclonal IgG antibodies. Protein A binds to most human and mouse IgG subclasses (e.g., human IgG1, IgG2, IgG4; mouse IgG2, IgG2a, IgG2b,IgG3). It also binds to cow, guinea pig, hamster, house, pig and rabbit total IgG form.Recombinant protein A can be coupled to solid separation medium (such as agarose) for monoclonaland polyclonal antibody purification. Recombinant protein A can be coupled to a variety of molecules (such as fluorescent molecules, enzyme markers, biotin, colloidal gold and radioactive markers). These coupled derivatives can be used in antibody test in the process of Western-blot, ELISA or immunohistochemical tests... Read More |