| Description | Extinction CoeffA280 nm = 1.35 at 1.0 mg/mLSpecificityMonospecific for human C2 in human plasma or serumGeneral DescriptionProduct is made from polyclonal antiserum from goats immunized with highly purified human complement protein. Product is the purified IgG fraction. Goats are maintained in FDA Extinction CoeffA280 nm = 1.35 at 1.0 mg/mLSpecificityMonospecific for human C2 in human plasma or serumGeneral DescriptionProduct is made from polyclonal antiserum from goats immunized with highly purified human complement protein. Product is the purified IgG fraction. Goats are maintained in FDA certified facilities.Physical Characteristics & StructureAntibodies present are primarily IgG.ApplicationsWestern Blots: Effective at dilutions 1/4,000 to 1/8,000 depending on conditions.Note: Most effective against non-reduced antigen.ELISA: Effective at dilutions 1/8,000 to 1/16,000 depending on conditions.Radial immunodiffusion: 1/44 dilution (Vol/Vol) of anti-C2 IgG fraction in agarose gel results, after staining, in clear precipitin rings with neat, 1:2 and 1:4 dilutions of NHS (3 mm wells, 20 µl sample).versus activated ½ diluted NHS assayed by immunodiffusion and staining of the precipitin band.Immunodiffusion: Effective at 1/8 dilution against NHS or plasma... Read More | Inquire | EPOCROSTM is a reactive polymer with an oxazoline group on the side chain and is used as a cross-linking agent for water-based resins. Among the water-based polymers developed to address environmental issues and the increasing use of water-based products due to VOC regulations and desolventing, the EPOCROSTM is a reactive polymer with an oxazoline group on the side chain and is used as a cross-linking agent for water-based resins. Among the water-based polymers developed to address environmental issues and the increasing use of water-based products due to VOC regulations and desolventing, the EPOCROSTM WS series is a “water-soluble type” with the following structure.Features and PropertiesHigher reactivity than water-based epoxy, melamine, blocked isocyanateVOC free (EPOCROS™ WS-300 and EPOCROS™ WS-700)High crosslinking density with a small amount addedOne-pack type with long usage timeImproves water resistance, solvent resistance, heat resistance, and the strength of films, etc.Adhesion-imparting possible to PET, OPP, PVC, etc.Fast dryingLow toxicity (Ames Test: Negative, Primary Skin Irritation Test: No irritation)WS Series Product LineupApplicationsNonwoven fabric bindersPigment printingCoatings (metals, films, leather)Paint and coatings, Primers (plastics, building materials, vehicles)AdhesivesMethodASSAY for Product Code DILW:One unit equals a decrease in absorbance of 1.0 per minute at 25°C at pH 7.5 with 2,6-dichlorophenolindophenol as the chromogen.Reagents0.2 M Tris⋅HCl buffer, pH 7.50.006 M NADH. Prepare fresh daily.0.0012 M Dichlorophenolindophenol (DCPIP) Prepare fresh daily.EnzymePrepare a 10 mg/ml solution of enzyme in 0.2 M Tris⋅HCl, pH 7.5.Dilute further immediately before use to give ΔA/min of 0.15-0.20.ProcedureAdjust spectrophotometer to 600 nm and 25°C.Pipette into cuvettes as follows:Mix quickly and measure the decrease in absorbance at 600 nm for 2-3 minutes.Determine the ΔA/min. from the initial linear portion of the curve. (Use portion of curve from t=0 to t=1 minute; the rate is linear for 1/2 to 1 minute.)Calculation... Read More | Inquire | Inquire |