| Description | Inquire | Inquire | Taq MasterMix is a premixed system composed of Taq DNA Polymerase, Mg2+, dNTPs, as well as PCR stabilizers and enhancers, with a concentration of 2 ×. The pre prepared PCR mixture makes the operation simpler and faster, and can minimize human error and contamination to the greatest extent Taq MasterMix is a premixed system composed of Taq DNA Polymerase, Mg2+, dNTPs, as well as PCR stabilizers and enhancers, with a concentration of 2 ×. The pre prepared PCR mixture makes the operation simpler and faster, and can minimize human error and contamination to the greatest extent possible. The original MasterMix formula results in high yield, strong repeatability, and good stability of amplified products. This product has been added with a dye (blue), and can be directly subjected to electrophoresis detection after the reaction is completed. The amplified PCR product has an "A" base attached to its 3 'end, making it suitable for direct use in T/A cloning. Mainly suitable for PCR amplification of DNA, DNA sequencing and other experiments. T665590Component5 mL25 mLStorageT665590A2×Taq MasterMix (Dye)5×1 mL5×5 mL-20℃. Avoid freeze/thaw cycle.T665590BddH₂O5×1 mL5×5 mL-20℃. Avoid freeze/thaw cycle.2×Taq MasterMix contains Taq DNA Polymerase, 3 mM Mg Cl₂ and 400 µM each dNTP. Quality control:After testing, there was no exogenous nuclease activity; PCR method for detecting residual DNA without host; Can effectively amplify single copy genes from multiple genomes.Usage:The following is an example of a PCR reaction system and reaction conditions for amplifying a 1 kb fragment using human genomic DNA as a template. In practical operation, corresponding improvements and optimizations should be made based on the template, primer structure, and target fragment size.1. PCR reaction system Reagent 50 µlReaction system Final concentration 2×Taq MasterMix（Dye） 25 µL 1× Forward Primer，10 µM 2 µL 0.4 µM Reverse Primer，10 µM 2 µl 0.4 µM Template DNA <0.5 µg <0.5 µg/50 µL ddH2O up to 50 µL /Attention: The primer concentration should be between 0.1 and 1.0 as the final concentration µ M serves as a reference for setting the range. In the case of low amplification efficiency, the concentration of primers can be increased; When non-specific reactions occur, the primer concentration can be reduced to optimize the reaction system.2. PCR reaction conditions Step Temperature Time / Pre denaturation 94℃ 2 min / Denaturation 94℃ 30 s 25-35 cycles Anneal 55-65℃ 30 s 25-35 cycles Extend 72℃ 30 s 25-35 cycles Finally extended 72℃ 2 min / Attention:1) In general experiments, if the annealing temperature is 5 ° C lower than the melting temperature Tm of the amplification primer, and the ideal amplification efficiency cannot be achieved, the annealing temperature should be appropriately reduced; When non-specific reactions occur, increase the annealing temperature to optimize the reaction conditions.2) The extension time should be set according to the size of the amplified fragment. The amplification efficiency of Taq DNA Polymerase in this product is 2 kb/min.3) The number of cycles can be set based on the downstream application of the amplification product. If the number of cycles is too small, the amplification amount is insufficient; If there are too many cycles, the probability of mismatches will increase, and non-specific backgrounds will be severe. So, while ensuring product yield, the number of cycles should be minimized as much as possible... Read More | Inquire | Acid phosphatase is an esterase with broad activity at an optimal pH below 7.0. There are three isozymes, EI, EII, and EIII of similar molecular weight (55 kDa± 5 kDa). Their optimum pH's are 5.5, 4.5, and 4.0 respectively. Acid phosphatase activity was observed by Teller Aladdin Library Acid phosphatase is an esterase with broad activity at an optimal pH below 7.0. There are three isozymes, EI, EII, and EIII of similar molecular weight (55 kDa± 5 kDa). Their optimum pH's are 5.5, 4.5, and 4.0 respectively. Acid phosphatase activity was observed by Teller Aladdin Library Archives in 1954 in preparations of a wheat germ lipase described by Singer JBC, 174, 11, in 1948. Equivalent commercial preparations have been distributed labeled as lipase and acid phosphatase thus generating some confusion. Subsequent work has confirmed that the non-specific esterase activity of the wheat germ preparation may be measured both as lipase (triacetin as substrate) and phosphatase. The enzyme assay is based on the work of Brandenberger and Hanson (Helv. Chim. Acta, 36, 900, 1953) and Hofstee ( Arch. Biochem. Biophys., 51, 239, 1954).Acid phosphatase (APase) non-specifically catalyzes the hydrolysis of monoesters and anhydrides of phosphoric acid to produce inorganic phosphate. It is used to study the production, transport, and recycling of phosphate and the metabolic and energy transduction processes of the cell.Characteristics of Acid Phosphatase from Wheat Germ:Molecular weight: 55,000 ± 5,000 (Verjee 1969).Composition: Three isozymes of closely similar molecular weights have been reported by Verjee (1969): EI, EII, and EIII. See also Brouillard and Ouellet (1965).Optimal pH: EI - 5.5, EII - 4.5, and EIII - 4.0. (Verjee 1969).Specificity: The enzyme has a broad esterase activity. See Joyce and Grisolia (1960). It shows highest activity for pyrophosphate.Inhibitors: Fluoride, molybdate and orthophosphate (Verjee 1969)... Read More |