| Description | Product content： E666027Component5 mLStorageE666027A2×Es Taq MasterMix (for PAGE)5×1 mL-20°C. Avoid freeze/thaw cycle.E666027BddH₂O5×1 mL-20°C. Avoid freeze/thaw cycle.Notes: 2×Es Taq MasterMix contain Es Taq DNA Polymerase, 3 mM MgCl₂ and 400 µMProduct content： E666027Component5 mLStorageE666027A2×Es Taq MasterMix (for PAGE)5×1 mL-20°C. Avoid freeze/thaw cycle.E666027BddH₂O5×1 mL-20°C. Avoid freeze/thaw cycle.Notes: 2×Es Taq MasterMix contain Es Taq DNA Polymerase, 3 mM MgCl₂ and 400 µM each dNTP. Product Introduction:This product is a premixed system composed of EsTaq DNA Polymerase, Mg2+, dNTPs, PCR stabilizers and enhancers, with a concentration of 2 ×. EsTaq DNA Polymerase has excellent performance of high amplification efficiency and low mismatch rate. The unique MasterMix formula makes the entire reaction system very stable, with over 98% of PCR amplification successful at once. At the same time, complex templates can also be effectively amplified, and human error and contamination can be minimized to the greatest extent. This product does not contain dyes. After the PCR program is completed, an appropriate amount of sample buffer can be added as needed for electrophoresis operation. Most PCR products obtained from amplification have an "A" base attached to the 3 'end, making them suitable for direct use in T/A cloning. Mainly suitable for conventional PCR reactions and gene cloning experiments that require high fidelity, PCR amplification products are specifically used for polyacrylamide gel electrophoresis detection.Quality control:After testing, there was no exogenous nuclease activity; PCR method for detecting residual DNA without host; Can effectively amplify single copy genes from multiple genomes.Usage:The following is an example of a PCR reaction system and reaction conditions for amplifying a 1 kb fragment using human genomic DNA as a template. In practical operation, corresponding improvements and optimizations should be made based on the template, primer structure, and target fragment size.1.pcr reaction systemreagent50 µlReaction systemfinal concentration2×Es Taq MasterMix（for Dye）25 µl1×Forward Primer，10 µM2 µl0.4 µMReverse Primer，10 µM2 µl0.4 µMTemplate DNA<0.5 µg<0.5 µg/50 µlddH2Oup to 50 µlAttention: The primer concentration should be between 0.1 and 1.0 as the final concentration µ M serves as a reference for setting the range. In the case of low amplification efficiency, the concentration of primers can be increased; When non-specific reactions occur, the primer concentration can be reduced to optimize the reaction system.2. PCR reaction conditions step temperature time / Pre denaturation 94℃ 2 min / denaturation 94℃ 30 s 25-35 cycle anneal 55-65℃ 30 s 25-35 cycle extend 72℃ 30 s 25-35 cycle Final extension 72℃ 2 min /Attention:1) In general experiments, if the annealing temperature is 5 ℃ lower than the melting temperature Tm of the amplification primer, and the ideal amplification efficiency cannot be achieved, the annealing temperature should be appropriately reduced; When non-specific reactions occur, increase the annealing temperature to optimize the reaction conditions.2) The extension time should be set according to the size of the amplified fragment, and the amplification efficiency of Es Taq DNA Polymerase is 2 kb/min.3) The number of cycles can be set based on the downstream application of the amplification product. If the number of cycles is too small, the amplification amount is insufficient; If there are too many cycles, the probability of mismatches will increase, and non-specific backgrounds will be severe. So, while ensuring product yield, the number of cycles should be minimized as much as possible... Read More | Inquire | General DescriptionNatural human C5a is prepared from human C5 protein cleaved into C5a and C5b by human C5 convertase. The C5a is converted to C5a desArg by proteolytic removal of the C-terminal arginine. The primary carboxypeptidase responsible for Arg removal is serum carboxypeptidase N, but General DescriptionNatural human C5a is prepared from human C5 protein cleaved into C5a and C5b by human C5 convertase. The C5a is converted to C5a desArg by proteolytic removal of the C-terminal arginine. The primary carboxypeptidase responsible for Arg removal is serum carboxypeptidase N, but there are several different carboxypepticases in serum. C5a desArg is a naturally glycosylated polypeptide containing 73 amino acids with a molecular weight of approx. 10,250 daltons. It contains 25% carbohydrate attached to a single Asn residue at position 64. This carbohydrate is of variable structure leading to a broad distribution of MW upon analysis by mass spectroscopy. C5a is the most potent anaplylatoxin (compared to C3a and C4a). C5a desArg is produced when C5a is“inactivated” by removal of its C-terminal arginine amino acid. This cleavage occurs by the action of the plasma enzyme carboxypeptidase N. This inactivation is rapid and most C5a is converted to C5a desArg within minutes of its formation. “Inactivated” C5a still possesses approx. 1% of its anaphylatoxic and chemotatic activities, but its stimulatory activity is only reduced 10-fold. Thus, C5a desArg retains considerable biological activity even though it is frequently called inactivated C5a. Its biological properties include being weakly chemotactic for neutrophils (PMN), causing smooth muscle contraction, increasing vascular permeability, causing histamine and TNF-alpha release, and causing lysosomal degranulation of immune cells. C5a and C5a desArg act through the C5a Receptor (C5aR, CD88, a G-protein coupled receptor) on PMN, monocytes, alveolar macrophages, and mast cells. A second receptor of unknown function (C5L2, gpr77) has been identified. Due to the widespread expression of C5a receptors and the results from C5aR KO mice it is believed that C5a and its receptors have many nonimmunolgical functions in organ development, CNS development, neurodegeneration, tissue regeneration and hematopoiesis (Monk, P.N. et al. (2007)).Native versus Recombinant C5a desArgNumerous recombinant forms of C5a and C5a desArg are sold by many companies. In side-by-side biological testing, we have found that our native native proteins are 10- to 100-fold more active per µg than all but one of these recombinant proteins. Structurally not a single one of the recombinant proteins on the market has the correct amino acid sequence or structure. They have extra amino acids at the N-terminal (such as 6 His tags), different amino acids in the sequence itself (some were produced from the original, but incorrect amino acid sequence), and none possess the 25% carbohydrate at Asn 64. In fact, one recombinant C5a on the market has approximately 30 additional amino acids at the N-terminal end due to the cloning vector used. This is a 40% addition of nonsense structure to the C5a molecule. Both our C5a and our C5adesArg are native proteins produced by the native human C5 convertase.Physical Characteristics & StructureDeglycosylated MW: Calculated monoisotopic mass 8112; Calculated average mass 8117.Isoelectric point: pI = 8.8Carbohydrate content: ~25% carbohydrate (heterogeneous) Amino acid sequence: TLQKKIEEIA AKYKHSVVKK CCYDGACVNN DETCEQRAAR ISLGPRCIKA FTECCVVASQ LRANISHKDM QLGMDL Number: MFCD00130842NMRderived structure: FEBS Lett. 238:289-294, 1988; Biochemistry 28:172-185,1989; Biochemistry 29:2895-2905, 1990; Proteins 28:261-267, 1997.Extinction Coeff. A280 nm = 0.41 at 1.0 mg/mlPurity: > 97% by SDS-PAGEAssaysThe multitude of biological functions of C5a has resulted in the use of many different assay systems. The most typical biological assays being smooth muscle contraction assays using guinea pig ileum, chemotaxis assays using neutrophils or granule-release assays using human PMN or similar cell lines. Granule release is generally followed by measuring the release of myeloperoxidase. Functional responses have been detected in the picomolar concentration range (Gerard, C. et al. (1981); Hugli, T.E. et al. (1981)).ELISA kits for the assay of C5a and C5a desArg in blood and other fluids are sold by many companies. These measurements are useful for detecting complement activation in vivo, but the interpretation of their meaning is complicated by the fact that clearance of the anaphylatoxins is rapid.In vivoThe resting serum concentration of C5a desArg has been reported to be approximately 4 nM although it is difficult to draw, store and test blood without 1 to 10 % C5 activation (Watkins, J. (1987)). The presence of EDTA and Futhan in the collection tubes can minimize this background. Full activation of all C5 in blood (75 µg/mL) would result in ~380 nM C5a (~3.9 µg/mL). Due to the extreme sensitivity of many C5a responses, a response can theoretically be initiated by activation of approximately one millionth of the C5 in a local area (sub-picomolar C5a).RegulationC5adesArg levels are regulated by two processes: formation and clearance. The enzymes that cleave C5 and release C5a (collectively called C5 convertases) do so at very slow rates. Operating at Vmax the best enzymes only cleave one C5 every three minutes (Rawal, N. and Pangburn, M.K. (2001)). C5a desArg is created when C5a is“inactivated” by removal of its C-terminal arginine amino acid. The product C5a desArg is produced by the action of the plasma enzyme carboxypeptidase N. This inactivation is rapid and most C5a is converted to C5a desArg within minutes of its formation. “Inactivated” C5a still possesses approx. 1% of its anaphylatoxic and chemotatic activities, but its stimulatory activity is only reduced 10-fold. Thus, C5a desArg retains considerable biological activity even though it is frequently called inactivated C5a. Because of the large number of cells bearing C5a receptors (endothelial, immune, smooth muscle, neuronal, etc.) the capture, internalization and digestion of C5a and C5a desArg results in their rapid removal from circulation.DeficienciesA deficiency of C5 or a deficiency of the enzymes that cleave C5 to generate C5a would result in the absence of C5a and C5a desArg. A knock-out mouse deficient in carboxypeptidase N has been created and found to be hypersensitive to complement activation and CVF administration (Mueller-Ortiz S.L. et al. (2009)). Administration of human C5a was 100% lethal in these KO mice probably due to their inability to inactivate C5a to C5a desArg. There are no known complete deficiencies of C5 convertases. Examples of C5 deficient humans and mice exist. In fact, many laboratory mouse strains in common use were shown to have been bred with a deficiency of C5 (A/HeJ, AKR/J, DBA/2J, NZB/B1NJ, SWR/J, and B10.D2/nSnJ). The lack of C5 prevents formation of the membrane attack complex of complement and precludes formation of C5a and C5a desArg. Humans lacking C5 are susceptible to repeated infections from a wide variety of organisms, primarily gram-negative bacteria. Meningococcal and gonococcal neisserial infections are especially problematic. The degree to which pathologies associated with C5 deficiency are due to the lack of C5 or due to the absence of C5a and C5a desArg is unclear but information on this isbeing acquired from receptor knock-out animals.DiseasesSee Deficiencies above.Precautions/Toxicity/HazardsThis protein is purified from human serum and therefore precautions appropriate for handling any blood-derived product must be used even though the source was shown by certified tests to be negative for HBsAg, HTLV-I/II, STS, and for antibodies to HCV, HIV-1 and HIV-II.Injection can cause anaphylatic shock which is a generalized circulatory collapse similar to that caused by an allergic reaction.Hazard Code: B WGK Germany 3MSDS available upon request... Read More | Inquire | Tyrosine decarboxylase catalyzes the removal of the carboxyl group from tyrosine to produce tyramine and carbon dioxide. Pyridoxal 5'-phosphate is a necessary cofactor. By using the apoenzyme prepared from cells grown on a vitamin B6 deficient medium pyridoxal phosphate may be determined. The Tyrosine decarboxylase catalyzes the removal of the carboxyl group from tyrosine to produce tyramine and carbon dioxide. Pyridoxal 5'-phosphate is a necessary cofactor. By using the apoenzyme prepared from cells grown on a vitamin B6 deficient medium pyridoxal phosphate may be determined. The HOLOenzyme may be used to determine tyrosine, phenylalanine and dihydroxyphenylalanine either manometrically or colorimetrically.L-Tyrosine decarboxylase apoenzyme from Streptococcus faecalis has been used in a study to purify and characterize tyrosine decarboxylase and aromatic-L-amino-acid decarboxylase.L-Tyrosine decarboxylase apoenzyme from Streptococcus faecalis has also been used in a study to investigate the stereospecificity of sodium borohydride reduction of tyrosine decarboxylase.One Unit yields 1µmole of CO2 per minute from L-tyrosine at 37°C, pH 5.5. The APOenzyme activity is measured in the presence of excess pyridoxal phosphate... Read More |