| Description | Inquire | 2x Taq MasterMix is a premixed system composed of Taq DNA Polymerase, Mg2+, dNTPs, PCR stabilizers, and enhancers. The pre prepared PCR mixture makes the operation simpler and faster, and can minimize human error and contamination to the greatest extent possible. The original MasterMix formula 2x Taq MasterMix is a premixed system composed of Taq DNA Polymerase, Mg2+, dNTPs, PCR stabilizers, and enhancers. The pre prepared PCR mixture makes the operation simpler and faster, and can minimize human error and contamination to the greatest extent possible. The original MasterMix formula results in high yield, strong repeatability, and good stability of amplified products. This product does not contain dyes. After the PCR program is completed, an appropriate amount of sample buffer can be added as needed for electrophoresis operation. The amplified PCR product has an "A" base attached to the 3 'end, making it suitable for direct use in T/A cloning. Mainly suitable for PCR amplification of DNA, DNA sequencing and other experiments.Quality control: T665627Component5mlStorageT665627A2×Taq MasterMix5×1ml-20℃. Avoid freeze/thaw cycle.T665627BddH₂O5×1ml-20℃. Avoid freeze/thaw cycle.Notes: 2×Taq MasterMix contains Taq DNA Polymerase, 3mM MgCl2 and 400µM each dNTP After testing, there was no exogenous nuclease activity; PCR method for detecting residual DNA without host; Can effectively amplify single copy genes from multiple genomes.Usage:The following is an example of a PCR reaction system and reaction conditions for amplifying a 1 kb fragment using human genomic DNA as a template. In practical operation, corresponding improvements and optimizations should be made based on the template, primer structure, and target fragment size.1. PCR reaction systemReagent50 µlReaction systemFinal concentration2×Taq MasterMix25 µl1×Forward Primer，10 µM2 µl0.4 µMReverse Primer，10 µM2 µl0.4 µMTemplate DNA<0.5 µg<0.5 µg/50 µlddH2Oup to 50 µl/Attention: The primer concentration should be between 0.1 and 1.0 as the final concentration µ M serves as a reference for setting the range. In the case of low amplification efficiency, the concentration of primers can be increased; When non-specific reactions occur, the primer concentration can be reduced to optimize the reaction system.2. PCR reaction conditionsStepTemperatureTime/Pre denaturation95℃2 min/Denaturation94℃30 s25-35 cyclesAnneal55-65℃30 s25-35 cyclesExtend72℃30 s25-35 cyclesFinally extended72℃2 min/Attention:1) In general experiments, if the annealing temperature is 5 ℃ lower than the melting temperature Tm of the amplification primer, and the ideal amplification efficiency cannot be achieved, the annealing temperature should be appropriately reduced; When non-specific reactions occur, increase the annealing temperature to optimize the reaction conditions.2) The extension time should be set according to the size of the amplified fragment. The amplification efficiency of Taq DNA Polymerase in this product is 2 kb/min.3) The number of cycles can be set based on the downstream application of the amplification product. If the number of cycles is too small, the amplification amount is insufficient; If there are too many cycles, the probability of mismatches will increase, and non-specific backgrounds will be severe. So, while ensuring product yield, the number of cycles should be minimized as much as possible... Read More | Protein Purity>90 % by SDS PAGEExtinction CoeffA280 nm = 0.725 at 1.0 mg/mL for pure C1s-C1INH ComplexMolecular Weight196,000 Da (1 chain)General DescriptionThe product C1s-C1INH Complex is made by interacting purified protease inhibitor C1-INH with purified C1s enzyme followed by purification. Protein Purity>90 % by SDS PAGEExtinction CoeffA280 nm = 0.725 at 1.0 mg/mL for pure C1s-C1INH ComplexMolecular Weight196,000 Da (1 chain)General DescriptionThe product C1s-C1INH Complex is made by interacting purified protease inhibitor C1-INH with purified C1s enzyme followed by purification. The protease inhibitor C1-INH prevents the spontaneous activation of complement and limits consumption of C2 and C4 by rapidly inactivating C1r, C1s and MASP2. It is the only plasma serine protease inhibitor (Serpin) capable of interacting with and inhibiting activated C1. C1-INH interacts with the catalytic sites of both C1r and C1s. The interaction with activated C1r and C1s is covalent resulting in complexes which are stable to SDS. C1s and C1r enzymes, however, are irreversibly inactivated by binding to C1-INH. C1s-C1INH is a very stable complex that remains intact even when subjected to freeze/thaw cycles with almost no loss of the complex form.Physical Characteristics & StructureThe C1s enzyme-C1INH complex is composed of two disulfide linked chains from C1s enzyme (A chain 58,000 Da and B chain 28,000 Da) and one covalently linked chain from C1-INH (75,000 Da).SDS-PAGE analysis of the C1s-C1INH complex shows a single band of about 161,000 Da under nonreducing conditions. Under reducing conditions, the C1s-C1INH complex exhibits two bands: A 58,000 Da band corresponding to the A chain of C1s enzyme and a second 103,000 Da band resulting from C1INH (75,000 Da) covalently bond to the B chain (28,000 Da) of C1s enzyme.RegulationActivated C1s is controlled by C1-INH. C1s enzyme and C1-INH form a covalent complex that is resistant to separation on SDS gels. During complement activation C1 complex is rapidly activated by binding to immune complexes. The resulting activated C1s and C1r are rapidly inactivated by interaction with C1-INH (Ziccardi, R.J. (1982)). Binding to immune complexes is fast (10-20 sec) and activation of the bound C1 complex takes several minutes, but C1-INH has also been shown to be fast and no active C1r or C1s remain 4 min after addition of immune complexes to plasma (Ross, G.D. (1986); Ziccardi,R.J. (1981)). The binding of C1-INH to activated C1 releases both C1r and C1s from the complex leaving C1q bound to the immune complex. The released complexes contain four molecules: C1-INH-C1r-C1s-C1-INH. The reaction of C1 esterase inhibitor with activated C1 is very fast with the estimated half-life of C1r and C1s being approximately 15 seconds in serum. In fact, at serum concentrations of C1- INH little or no additional C4 or C2 activation occurs 3 min after immune complexes are added because all the C1r and C1s molecules have been inactivated and removed from the C1q which remains bound to the immune complex (Ross, G.D. (1986); Morley, B.J. and Walport, M.J. (2000); Rother, K., et al. (1998); Ziccardi, R.J. (1982a and 1982b); Morgan, B.P. (1990)). The interaction of purified C1s enzyme and C1-INH is slower.FunctionSee General Description and Regulation above.ApplicationsC1s-C1INH complex can be used in studies designed for developing and identifying inhibitors of C1s-C1INH complex formation and thus lead to the possible development of therapeutics for inhibiting complement activation via the classical pathway.GeneticsThe EMBL/Genbank cDNA accession number for C1s is J04080. The gene for C1s is located on chromosome 12p13. The EMBL/Genbank cDNA accession numbers for C1-INH are M13656 and X54486 (human) and Y10386 (mouse). The gene for C1-INH is located on chromosome 11p11.2-13. DeficienciesC1s deficient patients are prone to systemic lupus erythematosus (SLE) and recurrent pyogenic infections (Rother, K., et al. (1998)). They lack classical pathway function. The genetic disorder hereditary angioedema (HAE) is caused by a partial deficiency of C1-INH. Patients with HAE have low functional C1-INH levels in blood and have recurrent episodes of systemic or localized edema.DiseasesSee section titled Deficiencies above. Precautions/Toxicity/HazardsThis protein is purified from human serum and therefore precautions appropriate for handling any blood-derived product must be used even though the source was shown by certified tests to be negative for HBsAg, HTLV-I/II, STS, and for antibodies to HCV, HIV-1 and HIV-II.ReferencesZiccardi, RJ. (1982) A new role for C-1-inhibitor in homeostasis: control of activation of the first component of human complement. J. Immunol. 128:2505-2508.Ross, G.D. (1986) Immunobiology of the Complement System. (ISBN 0-12-5976402) Academic Press, Orlando.Ziccardi, R.J. (1981) Activation of the early components of the classical complement pathway under physiologic conditions. J. Immunol. 126:1769-1773.Morley, B.J. and Walport, M.J. (2000) The Complement Facts Book. (ISBN 0127333606) Academic Press, London.Rother, K., Till, G.O., and Hӓnsch, G.M. (1998) The Complement System. (ISBN 3-540- 61894-5) Springer-Verlag, Heidelberg.Ziccardi, R.J. (1982a) Spontaneous activation of the first component of human complement (C1) by an intramolecular autocatalytic mechanism. J. Immunol. 128:2500- 2504.Ziccardi, RJ. (1982b) A new role for C-1-inhibitor in homeostasis: control of activation of the first component of human complement. J. Immunol. 128:2505-2508. Morgan, B.P. (1990) Complement Clinical Aspects and Relevance to Disease. (ISBN 0- 12-506955-3) Academic Press, London... Read More | Myelin Oligodendrocyte Glycoprotein Peptide (35-55), mouse, rat (MOG (35-55)) TFA is a minor component of CNS myelin. Myelin Oligodendrocyte Glycoprotein Peptide (35-55), mouse, rat TFA has encephalitogenic activity and induces T cell proliferative. Myelin Oligodendrocyte Glycoprotein Peptide Myelin Oligodendrocyte Glycoprotein Peptide (35-55), mouse, rat (MOG (35-55)) TFA is a minor component of CNS myelin. Myelin Oligodendrocyte Glycoprotein Peptide (35-55), mouse, rat TFA has encephalitogenic activity and induces T cell proliferative. Myelin Oligodendrocyte Glycoprotein Peptide (35-55), mouse, rat TFA induces Th1 cytokine response as well as relatively high levels of IgG antibodies. Myelin Oligodendrocyte Glycoprotein Peptide (35-55), mouse, rat TFA produces a relapsing-remitting neurological disease with extensive plaque-like demyelination... Read More | Protease-Activated Receptor-1, PAR-1 Agonist is a selective proteinase-activated receptor1 (PAR-1) agonist peptide. Protease-Activated Receptor-1, PAR-1 Agonist corresponds to PAR1 tethered ligand and which can selectively mimic theactions of thrombin via this receptorIn VitroProtease-Activated Protease-Activated Receptor-1, PAR-1 Agonist is a selective proteinase-activated receptor1 (PAR-1) agonist peptide. Protease-Activated Receptor-1, PAR-1 Agonist corresponds to PAR1 tethered ligand and which can selectively mimic theactions of thrombin via this receptorIn VitroProtease-Activated Receptor-1, PAR-1 Agonist induces activation of protein kinase C isoenzymes alpha and epsilon in human HT-29 colon carcinoma cells expressing PAR1 endogeneously. On the cellular level, Protease-Activated Receptor-1, PAR-1 Agonist and thrombin prompted HT-29 cell migration and matrix adhesion by a PKCepsilon-dependent mechanism as concluded because of the inhibition of PAR1-mediated effects by the PKC inhibitor bisindolylmaleimide I and the PKCepsilon translocation inhibitory peptide EAVSLKPT but not by the PKC inhibitor Gö 6976. MCE has not independently confirmed the accuracy of these methods. They are for reference only.Form:SolidIC50& Target:PAR-1... Read More |