| Description | The 100bp DNA ladder is composed of 11 linear double stranded DNA bands, which is suitable for accurately judging the size of DNA fragments in the range of 100 bp-1500 BP in agarose gel electrophoresis, and is not recommended for acrylamide gel electrophoresis. This product is ready to use The 100bp DNA ladder is composed of 11 linear double stranded DNA bands, which is suitable for accurately judging the size of DNA fragments in the range of 100 bp-1500 BP in agarose gel electrophoresis, and is not recommended for acrylamide gel electrophoresis. This product is ready to use and contains 1 × Loading buffer can directly load samples for electrophoresis according to experimental needs, which is convenient to use and has clear electrophoresis images. Among them, the 500 BP band is shown as a bright bandRecommended electrophoretic buffer:Recommended electrophoresis buffer:TBEMatters needing attention:1.Please instantaneously centrifuge the product to the bottom of the tube before use, and then carry out subsequent experiments.2.Please replace the electrophoresis buffer in time and use the new gel to avoid affecting the electrophoresis results.3.Avoid repeated freezing and thawing.Instruction:1.Electrophoresis can be carried out with GelstainRed, and 5µL is added to the sample hole of agarose gel for electrophoresis.2.It is recommended that the electrophoresis conditions are 2-3 % agarose gel, voltage 4-10V / cm.3.Staining with GelstainRed or other dyes to observe the electrophoretic bands.Product parameters:Ribbon composition:100 bp,200 bp,300 bp,400 bp,500 bp,600bp,700 bp,800 bp,900 bp,1000 bp,1500 bp Scope of application:DNA ladder... Read More | EPOCROSTM is a reactive polymer with an oxazoline group on the side chain and is used as a cross-linking agent for water-based resins. Among the water-based polymers developed to address environmental issues and the increasing use of water-based products due to VOC regulations and desolventing, the EPOCROSTM is a reactive polymer with an oxazoline group on the side chain and is used as a cross-linking agent for water-based resins. Among the water-based polymers developed to address environmental issues and the increasing use of water-based products due to VOC regulations and desolventing, the EPOCROSTM WS series is a “water-soluble type” with the following structure.Features and PropertiesHigher reactivity than water-based epoxy, melamine, blocked isocyanateVOC free (EPOCROS™ WS-300 and EPOCROS™ WS-700)High crosslinking density with a small amount addedOne-pack type with long usage timeImproves water resistance, solvent resistance, heat resistance, and the strength of films, etc.Adhesion-imparting possible to PET, OPP, PVC, etc.Fast dryingLow toxicity (Ames Test: Negative, Primary Skin Irritation Test: No irritation)WS Series Product LineupApplicationsNonwoven fabric bindersPigment printingCoatings (metals, films, leather)Paint and coatings, Primers (plastics, building materials, vehicles)AdhesivesMethodASSAY for Product Code DILW:One unit equals a decrease in absorbance of 1.0 per minute at 25°C at pH 7.5 with 2,6-dichlorophenolindophenol as the chromogen.Reagents0.2 M Tris⋅HCl buffer, pH 7.50.006 M NADH. Prepare fresh daily.0.0012 M Dichlorophenolindophenol (DCPIP) Prepare fresh daily.EnzymePrepare a 10 mg/ml solution of enzyme in 0.2 M Tris⋅HCl, pH 7.5.Dilute further immediately before use to give ΔA/min of 0.15-0.20.ProcedureAdjust spectrophotometer to 600 nm and 25°C.Pipette into cuvettes as follows:Mix quickly and measure the decrease in absorbance at 600 nm for 2-3 minutes.Determine the ΔA/min. from the initial linear portion of the curve. (Use portion of curve from t=0 to t=1 minute; the rate is linear for 1/2 to 1 minute.)Calculation... Read More | Inquire | Inquire | Purity>97% SDS-PAGE.FunctionReceptor for interleukin-2 |