| Description | Product Description:1. This product consists of thirteen linear double-stranded DNA fragments with a size range of 250bp to 12kb, specifically 250bp, 500bp, 750bp, 1000bp, 1500bp, 2000bp, 2500bp, 3000bp, 4000bp, 5000bp, 6000bp, 8000bp, and 12000bp. The 1500bp and 4000bp bands serve as intensified Product Description:1. This product consists of thirteen linear double-stranded DNA fragments with a size range of 250bp to 12kb, specifically 250bp, 500bp, 750bp, 1000bp, 1500bp, 2000bp, 2500bp, 3000bp, 4000bp, 5000bp, 6000bp, 8000bp, and 12000bp. The 1500bp and 4000bp bands serve as intensified indicator bands, with a concentration 2.5 times higher than that of the other bands, facilitating observation after electrophoresis.2. In 5µl of this product, the content of the regular bands is approximately 30ng, while the content of the intensified band is about 75ng. This product is already preserved in a 1x Loading Buffer and can be directly used for electrophoresis, offering convenience in use.3. Both this product and the accompanying 5x Loading Buffer contain the Gelred nucleic acid stain. When used together, after electrophoresis, the bands can be directly observed under ultraviolet light without the need for subsequent staining procedures.4. This product is not suitable for polyacrylamide gel electrophoresis.Recommended Electrophoresis Buffer and Agarose Gel Concentration:It is recommended to use 1x TAE electrophoresis buffer for this product, with a recommended agarose concentration of 1.0% to 1.5%. When using this product system, no additional nucleic acid stains are required in the agarose gel.Usage Instructions:1. Prepare an agarose gel of the appropriate concentration without any nucleic acid stains.2. The concentration of the agarose gel has a significant impact on DNA electrophoresis. The recommended agarose gel concentration for this product is 1.0% to 1.5%.3. It is suggested to use 1x TAE buffer for electrophoresis, with a voltage not exceeding 10v/cm.4. For common 3.5mm sample wells, the recommended volume of DNA marker is 3 to 5µl. For wider gel wells, the sample volume should be appropriately increased.5. Mix the samples to be tested with the accompanying 5x Loading Buffer at a ratio of approximately 4:1, and then load into the gel sample wells.6. Run the electrophoresis to an appropriate distance:Since Gelred binds firmly to DNA, it is possible to fully utilize the length of the gel and run a longer distance, as long as the smallest fragment does not run out of the gel, which is beneficial for the separation of small fragments. Generally, the bromophenol blue indicator band should be no less than 1cm away from the edge of the gel.7. After electrophoresis, observe the electrophoresis bands under a UV lamp.8. The 5x Loading Buffer included in the product is used for mixing with the samples to be tested before loading, and it contains both bromophenol blue and xylene cyan FF as dual indicators.9. If there are a large number of samples that can be directly loaded for electrophoresis testing, it is recommended to use the Gelred gel method for detection, without pre-mixing the samples, which can greatly save experimental time.Product componentR751625Component100 T500TStorageR751625AGelred-prestained DNA Ladder (250-12000bp)500 µL5× 500 µL-20℃. Avoid freeze/thaw cycle.R751625BGelred-prestained 5xLoading buffer 500 µL5× 500 µL-20℃. Avoid freeze/thaw cycle... Read More | DescriptionApolipoprotein E (ApoE) is present in the brain and is mainly produced by astrocytes. It is a 299 amino acid glycoprotein of 34kDa. It is present in all classes of lipoproteins except LDL (low-density lipoprotein). APOE gene has three alleles, such as APOE ε3, APOE ε4and APOE &#DescriptionApolipoprotein E (ApoE) is present in the brain and is mainly produced by astrocytes. It is a 299 amino acid glycoprotein of 34kDa. It is present in all classes of lipoproteins except LDL (low-density lipoprotein). APOE gene has three alleles, such as APOE ε3, APOE ε4and APOE ε2. It is located on human chromosome 19q13.Preparation instructionsFormLyophillized from a 0.2 µm filtered solution in 20 mM sodium phosphate, pH 7.8.Principle... Read More | Aprotinin is a competitive serine protease inhibitor that inhibits trypsin,chymotrypsin,kallikrein and plasmin.Aprotinin forms stable complexes with and blocks the active sites of enzymes. Binding is reversible with most aprotinin,protease complexes and dissociating at pH >10 or <3. Effective Aprotinin is a competitive serine protease inhibitor that inhibits trypsin,chymotrypsin,kallikrein and plasmin.Aprotinin forms stable complexes with and blocks the active sites of enzymes. Binding is reversible with most aprotinin,protease complexes and dissociating at pH >10 or <3. Effective concentration is equimolar with protease.Recombinant aprotinin is expressed in E. Coli, and purified with HPLC. It contains no animal-derived components. This is a recombinant form of bovine lung aprotinin, which is traditionally isolated from bovine lung by methods involving fractional precipitation, gel filtration, and ion exchange chromatography. UNIT DEFINITION:A conversion factor for Aprotinin is: 1 EPU = 1 USP Aprotinin Unit = 1800 KIU... Read More | Purity:>95%, by SDS-PAGE visualized with Coomassie® Blue Staining.Description:GAPDH (Glyceraldehyde-3-Phosphate Dehydrogenase) is a Protein Coding gene. Diseases associated with GAPDH include Microcephaly 21, Primary, Autosomal Recessive and Schistosomiasis. Among its related pathways are Purity:>95%, by SDS-PAGE visualized with Coomassie® Blue Staining.Description:GAPDH (Glyceraldehyde-3-Phosphate Dehydrogenase) is a Protein Coding gene. Diseases associated with GAPDH include Microcephaly 21, Primary, Autosomal Recessive and Schistosomiasis. Among its related pathways are glycolysis (BioCyc) and gluconeogenesis III. Gene Ontology (GO) annotations related to this gene include identical protein binding and NAD binding. An important paralog of this gene is GAPDHS... Read More | The recombinant Protein A is a genetically engineering protein containing IgG-binding domains.Recombinant Protein A is ideal for purification of polyclonal or monoclonal IgG antibodies. Protein A binds to most human and mouse IgG subclasses (e.g., human IgG1, IgG2, IgG4; mouse IgG2, IgG2a, IgG2b,The recombinant Protein A is a genetically engineering protein containing IgG-binding domains.Recombinant Protein A is ideal for purification of polyclonal or monoclonal IgG antibodies. Protein A binds to most human and mouse IgG subclasses (e.g., human IgG1, IgG2, IgG4; mouse IgG2, IgG2a, IgG2b,IgG3). It also binds to cow, guinea pig, hamster, house, pig and rabbit total IgG form.Recombinant protein A can be coupled to solid separation medium (such as agarose) for monoclonaland polyclonal antibody purification. Recombinant protein A can be coupled to a variety of molecules (such as fluorescent molecules, enzyme markers, biotin, colloidal gold and radioactive markers). These coupled derivatives can be used in antibody test in the process of Western-blot, ELISA or immunohistochemical tests... Read More |