| Description | Enzymes extracted from mammalian testes (e.g., sheep testes) can hydrolyze mucopolysaccharides of the hyaluronic acid type. They may contain a suitable stabilizer. Potency: Minimum 1000 IU of hyaluronidase activity per milligram (of dry substance).ProductionAnimals used for producing hyaluronidase Enzymes extracted from mammalian testes (e.g., sheep testes) can hydrolyze mucopolysaccharides of the hyaluronic acid type. They may contain a suitable stabilizer. Potency: Minimum 1000 IU of hyaluronidase activity per milligram (of dry substance).ProductionAnimals used for producing hyaluronidase must meet the health requirements for animals intended for human consumption.CharacteristicsAppearance: White or yellowish-white, amorphous powder.Solubility: Soluble in water, almost insoluble in acetone and absolute ethanol.IdentificationA solution containing 100 IU of hyaluronidase in 1 mL of 9 g/L sodium chloride solution depolymerizes a 10 g/L sodium hyaluronate BRP solution at 20°C, resulting in a significant decrease in viscosity. Heating the hyaluronidase at 100°C for 30 minutes destroys this effect.Tests1.Appearance of Solution: The solution should be clear. Dissolve 0.10 g in water and dilute to 10 mL with the same solvent.2.pH: 4.5 to 7.5. Dissolve 30 mg in carbon dioxide-free water and dilute to 10 mL with the same solvent.3.Loss on Drying: Maximum 5.0%. Determine by drying 0.500 g at 60°C under a pressure not exceeding 670 Pa for 2 hours.4.Bacterial Endotoxins: ≤ 0.2 EU/IU.AssayThe activity of hyaluronidase is determined using a slope-ratio assay, by comparing the rate at which it hydrolyzes sodium hyaluronate BRP with the rate obtained using the International Standard or a reference preparation calibrated in International Units.Substrate SolutionIn a 25 mL conical flask, add 0.10 g of sodium hyaluronate BRP, then slowly add 20.0 mL of water at 4°C. The addition rate must be slow enough to allow the substrate particles to swell (approximately 5 minutes). Maintain at 4°C and stir for at least 12 hours. Store at 4°C and use within 4 days.For both the test solution and the reference solution, prepare the solutions and perform dilutions at 0°C to 4°C.Test Solution: Dissolve an appropriate amount of the substance in hyaluronidase diluent to obtain a solution containing 0.6 ± 0.3 IU of hyaluronidase per mL.Reference Solution: Dissolve an appropriate amount of hyaluronidase BRP in hyaluronidase diluent to obtain a solution containing 0.6 IU of hyaluronidase per mL.In a reaction vessel, mix 1.50 mL of phosphate buffer solution (pH 6.4) and 1.0 mL of the substrate solution, and equilibrate at 37 ± 0.1°C. At time t₀ = 0 (using the first timer), add 0.50 mL of the test solution containing E milligrams of the enzyme to be tested, mix well. Maintain the mixture at 37 ± 0.1°C using a suitable viscometer, record the flow time t using a second timer (with 0.1-second intervals), and perform multiple measurements over approximately 20 minutes (monitoring with the first timer). Use the following viscometer: microviscometer (DIN 51 562, Part 2), capillary type MII, with a viscometer constant of approximately 0.1 mm²/s².Repeat the above procedure using 0.50 mL of the reference solution containing hyaluronidase BRP. Calculate the viscosity ratio using the following expression:K = Viscometer constant (in mm²/s², indicated on the viscometer);t₂ = Flow time of the solution (in seconds);0.6915 = Kinematic viscosity of the buffer solution at 37°C (in mm²/s).Since the enzymatic reaction continues during the flow time measurement, the actual reaction time is equal to t₀ + t/2 (i.e., half of the flow time (t/2) is added to the initial measurement time t₀). Plot (ln η)⁻¹ as a function of the reaction time (t₀ + t/2) (in seconds); a linear relationship should be obtained. Calculate the slope (b) of the substance to be tested and the slope (bᵣ) of the reference preparation. Determine the specific activity in International Units per milligram using the following expression:A = Specific activity of hyaluronidase BRP (in International Units per milligram).Perform at least three complete sets of the procedure and calculate the average activity of the substance to be tested.StorageStore in a tightly closed container at a temperature of 2°C to 8°C. If the substance is sterile, the container should also be sterile and tamper-proof.
Hyaluronidase is present in high amount in testis as it aids fertilization of the mammalian egg. Mammalian hyaluronidase has a catalytic epidermal growth factor (EGF)-like domain and a C-terminal cysteine rich region.Application:Hyaluronidase has been used:as a component of enzyme mix for the isolation of sertoli and germ cells from seminiferous tubulesin the pre-treatment of deparaffinized adenomas sections for immunohistochemistryin the digestion of umbilical cord blood vessel for the generation of umbilical cord stromal stem cell lines... Read More | HIV-1 Tat Protein Peptide is a synthetic peptide that includes the sequence responsible for the cellular uptake of the human immunodeficiency virus-1 Tat protein, consisting of the polycationic region 49-57. The peptide is part of the protein transduction domain (PTD) and was shown to enable the HIV-1 Tat Protein Peptide is a synthetic peptide that includes the sequence responsible for the cellular uptake of the human immunodeficiency virus-1 Tat protein, consisting of the polycationic region 49-57. The peptide is part of the protein transduction domain (PTD) and was shown to enable the introduction of nucleic acids into cells... Read More | Purity:>95%, by SDS-PAGE visualized with Coomassie® Blue Staining.Description：CD4, also known as L3T4, T4, and W3/25, is an approximately 55 kDa type I transmembrane glycoprotein that is expressed predominantly on thymocytes and a subset of mature T lymphocytes. It is a standard Purity:>95%, by SDS-PAGE visualized with Coomassie® Blue Staining.Description：CD4, also known as L3T4, T4, and W3/25, is an approximately 55 kDa type I transmembrane glycoprotein that is expressed predominantly on thymocytes and a subset of mature T lymphocytes. It is a standard phenotype marker for the identification of T cell populations. Mature feline CD4 consists of a 388 amino acid (aa) extracellular region containing four immunoglobulin-like domains, a 22 aa transmembrane segment, and a 40 aa cytoplasmic domain. Within the ECD, feline CD4 shares 70%, 58%, 50%, and 48% aa sequence identity with canine, human, mouse and rat CD4, respectively. CD4 is expressed along with CD8 on double positive T cells during their development in the thymus. Either CD4 or CD8 expression is then lost, giving rise to single positive (SP) CD4+ or CD8+ mature T cells. CD4+ SP cells, also known as T helper cells, further differentiate into multiple subsets of CD4+ cells including Th1, Th2, Th17, Tfh, and Treg cells which regulate humoral and cellular immunity. CD4 is reexpressed on circulating CD8+ T cells upon activation and contributes to their cytotoxic effector activity. In human, CD4 is additionally expressed on macrophages, neutrophils, monocytes, NK cells, and neurons and glial cells in the brain. Similar CD4 distribution between species cannot be assumed as demonstrated by its presence on macrophages in human and rat but not in mouse. CD4 binds directly to MHC class II molecules on antigen presenting cells. This interaction contributes to the formation of the immunological synapse which is focused around the TCR-MHC class II-antigenic peptide interaction. Palmitoylation of two cysteine residues in the cytoplasmic tail of CD4 promotes the localization of CD4 in lipid rafts and its ability to augment TCR signaling via activation of the tyrosine kinase Lck. CD4 also functions as a chemotactic receptor for IL-16 and, in human, as a coreceptor for the gp120 surface glycoprotein of HIV-1... Read More | Purity:>95%, by SDS-PAGE visualized with Coomassie® Blue Staining. Description： 100B, previously called S100 beta, belongs to the S100 family within the EF-hand superfamily of Ca2+ binding proteins. S100 proteins contain two EF-hand motifs that differ in affinity, separated by a hingePurity:>95%, by SDS-PAGE visualized with Coomassie® Blue Staining. Description： 100B, previously called S100 beta, belongs to the S100 family within the EF-hand superfamily of Ca2+ binding proteins. S100 proteins contain two EF-hand motifs that differ in affinity, separated by a hinge region with a hydrophobic cleft that is exposed upon Ca2+ binding. S100B is a 91 amino acid (aa) protein, after removal of the initial methionine, and is found as homodimers of 10.4 kDa monomers. Human S100B shares 99%, 98%, 100%, 99% and 97% aa sequence identity with mouse, rat, rabbit, equine and bovine S100B, respectively. Within the S100 family, human S100B shows the highest aa identity (59%) with S100A1. S100B is expressed primarily by astrocytes and oligodendrocytes in the central nervous system, and by Schwann cells in the peripheral nervous system. Ca2+-bound S100B interacts in vitro with at least 20 cytoplasmic proteins, including several structural molecules such as tubulin and GFAP. It can inhibit the phosphorylation of these kinase substrates and others such as tau and neuromodulin. Astrocytes can secrete S100B, which then acts in a cytokine-like manner. Nanomolar concentrations of S100B are secreted constitutively, promote proliferation, and are neurotrophic and anti-apoptotic. Blood levels of S100B reflect extracellular concentrations within the nervous system, and are elevated in Down’s syndrome, Alzheimer’s disease and Tourette’s syndrome, metabolic stress, acute brain injury and brain tumors. Micromolar concentrations of S100B can be destructive and pro-apoptotic; they induce the expression of iNOS, COX-2, IL-1, IL‑6 and TNF-alpha by microglia, astrocytes or neurons. Most extracellular actions of S100B can be mediated by RAGE (receptor for advanced glycation end products), which is also a receptor for other S100 proteins... Read More | Purity>95% SDS-PAGE.Additional sequence informationFull length mature chain without signal peptide.FunctionLineage-specific cytokine affecting the proliferation and maturation of megakaryocytes from their committed progenitor cells. It acts at a late stage of megakaryocyte development. It may be Purity>95% SDS-PAGE.Additional sequence informationFull length mature chain without signal peptide.FunctionLineage-specific cytokine affecting the proliferation and maturation of megakaryocytes from their committed progenitor cells. It acts at a late stage of megakaryocyte development. It may be the major physiological regulator of circulating platelets... Read More |