| Description | Product introduction：It is mainly used for the isolation of human peripheral blood lymphocytesMatters needing attention：1. operate under sterile conditions and store at room temperature after sealing. 2. samples, reagents and experimental environment in the whole process shall be Product introduction：It is mainly used for the isolation of human peripheral blood lymphocytesMatters needing attention：1. operate under sterile conditions and store at room temperature after sealing. 2. samples, reagents and experimental environment in the whole process shall be carried out at 20 ± 2 ℃. In order to obtain the best experimental results, it is best to carry out the experiment within 2 h after taking blood. The longer the blood is stored, the worse the cell separation effect is. After the blood is placed for more than 6h, the separation effect is worse or even can not achieve the purpose of separation. 3. in this experiment, it is better not to use plastic products with high polymerization materials (such as polystyrene), but use non-static, low static ionization heart tubes and glass products without alkali treatment, because the electrostatic effect will lead to cell adhesion, and the surface of alkali treated glass will become rough, which will affect the effect of cell separation. 4. aspirating too many lymphocyte layers and separation liquid layers will cause the granulocytes at the junction of separation liquid to be aspirated, thus increasing the number of mixed granulocytes. 5. absorbing too much upper layer solution of lymphocyte layer will lead to the mixing of plasma proteins and platelets. 6. when the blood sample viscosity is too high and needs to be diluted, the optimal dilution method is: dilute and mix the blood and sample diluent (product No.: h9044) 1:1 for standby. Note: improper dilution method will reduce cell yield and activity. If the blood sample is diluted, the centrifugal force and centrifugation time should be appropriately reduced during the separation process. 7. due to the individual differences of blood samples and different blood viscosity, the centrifugal force and centrifugal time should be adjusted. The maximum centrifugal force should not exceed 1000 g.Scope of application：Lymphocyte isolation... Read More | General DescriptionNatural human C5a is prepared from human C5 protein cleaved into C5a and C5b by human C5 convertase. The C5a is converted to C5a desArg by proteolytic removal of the C-terminal arginine. The primary carboxypeptidase responsible for Arg removal is serum carboxypeptidase N, but General DescriptionNatural human C5a is prepared from human C5 protein cleaved into C5a and C5b by human C5 convertase. The C5a is converted to C5a desArg by proteolytic removal of the C-terminal arginine. The primary carboxypeptidase responsible for Arg removal is serum carboxypeptidase N, but there are several different carboxypepticases in serum. C5a desArg is a naturally glycosylated polypeptide containing 73 amino acids with a molecular weight of approx. 10,250 daltons. It contains 25% carbohydrate attached to a single Asn residue at position 64. This carbohydrate is of variable structure leading to a broad distribution of MW upon analysis by mass spectroscopy. C5a is the most potent anaplylatoxin (compared to C3a and C4a). C5a desArg is produced when C5a is“inactivated” by removal of its C-terminal arginine amino acid. This cleavage occurs by the action of the plasma enzyme carboxypeptidase N. This inactivation is rapid and most C5a is converted to C5a desArg within minutes of its formation. “Inactivated” C5a still possesses approx. 1% of its anaphylatoxic and chemotatic activities, but its stimulatory activity is only reduced 10-fold. Thus, C5a desArg retains considerable biological activity even though it is frequently called inactivated C5a. Its biological properties include being weakly chemotactic for neutrophils (PMN), causing smooth muscle contraction, increasing vascular permeability, causing histamine and TNF-alpha release, and causing lysosomal degranulation of immune cells. C5a and C5a desArg act through the C5a Receptor (C5aR, CD88, a G-protein coupled receptor) on PMN, monocytes, alveolar macrophages, and mast cells. A second receptor of unknown function (C5L2, gpr77) has been identified. Due to the widespread expression of C5a receptors and the results from C5aR KO mice it is believed that C5a and its receptors have many nonimmunolgical functions in organ development, CNS development, neurodegeneration, tissue regeneration and hematopoiesis (Monk, P.N. et al. (2007)).Native versus Recombinant C5a desArgNumerous recombinant forms of C5a and C5a desArg are sold by many companies. In side-by-side biological testing, we have found that our native native proteins are 10- to 100-fold more active per µg than all but one of these recombinant proteins. Structurally not a single one of the recombinant proteins on the market has the correct amino acid sequence or structure. They have extra amino acids at the N-terminal (such as 6 His tags), different amino acids in the sequence itself (some were produced from the original, but incorrect amino acid sequence), and none possess the 25% carbohydrate at Asn 64. In fact, one recombinant C5a on the market has approximately 30 additional amino acids at the N-terminal end due to the cloning vector used. This is a 40% addition of nonsense structure to the C5a molecule. Both our C5a and our C5adesArg are native proteins produced by the native human C5 convertase.Physical Characteristics & StructureDeglycosylated MW: Calculated monoisotopic mass 8112; Calculated average mass 8117.Isoelectric point: pI = 8.8Carbohydrate content: ~25% carbohydrate (heterogeneous) Amino acid sequence: TLQKKIEEIA AKYKHSVVKK CCYDGACVNN DETCEQRAAR ISLGPRCIKA FTECCVVASQ LRANISHKDM QLGMDL Number: MFCD00130842NMRderived structure: FEBS Lett. 238:289-294, 1988; Biochemistry 28:172-185,1989; Biochemistry 29:2895-2905, 1990; Proteins 28:261-267, 1997.Extinction Coeff. A280 nm = 0.41 at 1.0 mg/mlPurity: > 97% by SDS-PAGEAssaysThe multitude of biological functions of C5a has resulted in the use of many different assay systems. The most typical biological assays being smooth muscle contraction assays using guinea pig ileum, chemotaxis assays using neutrophils or granule-release assays using human PMN or similar cell lines. Granule release is generally followed by measuring the release of myeloperoxidase. Functional responses have been detected in the picomolar concentration range (Gerard, C. et al. (1981); Hugli, T.E. et al. (1981)).ELISA kits for the assay of C5a and C5a desArg in blood and other fluids are sold by many companies. These measurements are useful for detecting complement activation in vivo, but the interpretation of their meaning is complicated by the fact that clearance of the anaphylatoxins is rapid.In vivoThe resting serum concentration of C5a desArg has been reported to be approximately 4 nM although it is difficult to draw, store and test blood without 1 to 10 % C5 activation (Watkins, J. (1987)). The presence of EDTA and Futhan in the collection tubes can minimize this background. Full activation of all C5 in blood (75 µg/mL) would result in ~380 nM C5a (~3.9 µg/mL). Due to the extreme sensitivity of many C5a responses, a response can theoretically be initiated by activation of approximately one millionth of the C5 in a local area (sub-picomolar C5a).RegulationC5adesArg levels are regulated by two processes: formation and clearance. The enzymes that cleave C5 and release C5a (collectively called C5 convertases) do so at very slow rates. Operating at Vmax the best enzymes only cleave one C5 every three minutes (Rawal, N. and Pangburn, M.K. (2001)). C5a desArg is created when C5a is“inactivated” by removal of its C-terminal arginine amino acid. The product C5a desArg is produced by the action of the plasma enzyme carboxypeptidase N. This inactivation is rapid and most C5a is converted to C5a desArg within minutes of its formation. “Inactivated” C5a still possesses approx. 1% of its anaphylatoxic and chemotatic activities, but its stimulatory activity is only reduced 10-fold. Thus, C5a desArg retains considerable biological activity even though it is frequently called inactivated C5a. Because of the large number of cells bearing C5a receptors (endothelial, immune, smooth muscle, neuronal, etc.) the capture, internalization and digestion of C5a and C5a desArg results in their rapid removal from circulation.DeficienciesA deficiency of C5 or a deficiency of the enzymes that cleave C5 to generate C5a would result in the absence of C5a and C5a desArg. A knock-out mouse deficient in carboxypeptidase N has been created and found to be hypersensitive to complement activation and CVF administration (Mueller-Ortiz S.L. et al. (2009)). Administration of human C5a was 100% lethal in these KO mice probably due to their inability to inactivate C5a to C5a desArg. There are no known complete deficiencies of C5 convertases. Examples of C5 deficient humans and mice exist. In fact, many laboratory mouse strains in common use were shown to have been bred with a deficiency of C5 (A/HeJ, AKR/J, DBA/2J, NZB/B1NJ, SWR/J, and B10.D2/nSnJ). The lack of C5 prevents formation of the membrane attack complex of complement and precludes formation of C5a and C5a desArg. Humans lacking C5 are susceptible to repeated infections from a wide variety of organisms, primarily gram-negative bacteria. Meningococcal and gonococcal neisserial infections are especially problematic. The degree to which pathologies associated with C5 deficiency are due to the lack of C5 or due to the absence of C5a and C5a desArg is unclear but information on this isbeing acquired from receptor knock-out animals.DiseasesSee Deficiencies above.Precautions/Toxicity/HazardsThis protein is purified from human serum and therefore precautions appropriate for handling any blood-derived product must be used even though the source was shown by certified tests to be negative for HBsAg, HTLV-I/II, STS, and for antibodies to HCV, HIV-1 and HIV-II.Injection can cause anaphylatic shock which is a generalized circulatory collapse similar to that caused by an allergic reaction.Hazard Code: B WGK Germany 3MSDS available upon request... Read More | HIV-1 Tat Protein Peptide is a synthetic peptide that includes the sequence responsible for the cellular uptake of the human immunodeficiency virus-1 Tat protein, consisting of the polycationic region 49-57. The peptide is part of the protein transduction domain (PTD) and was shown to enable the HIV-1 Tat Protein Peptide is a synthetic peptide that includes the sequence responsible for the cellular uptake of the human immunodeficiency virus-1 Tat protein, consisting of the polycationic region 49-57. The peptide is part of the protein transduction domain (PTD) and was shown to enable the introduction of nucleic acids into cells... Read More | Purity:>90%, by SDS-PAGE visualized with Coomassie® Blue Staining.Implicated in the control of cell proliferation and cellular aging. May also act as a chaperone | Trypsin is a member of the serine protease family. Trypsin cleaves peptides on the C-terminal end of lysine and arginine amino acid residues. The pH optimum of trypsin is pH 7 - 10. The enzyme is inhibited by serine protease inhibitors, e.g. PMSF, and by metal chelating agents, e.g., EDTA. Trypsin is a member of the serine protease family. Trypsin cleaves peptides on the C-terminal end of lysine and arginine amino acid residues. The pH optimum of trypsin is pH 7 - 10. The enzyme is inhibited by serine protease inhibitors, e.g. PMSF, and by metal chelating agents, e.g., EDTA. Recombinant Human Trypsin is a genetically engineered protein expressed in E.coli and purified by high pressure liquid chromatography. There are no contaminating enzyme activities such as carboxypeptidase A and chymotrypsin. No protease inhibitors such as PMSF are contained in the preparation.Animal origin free:The use of recombinant Human Trypsin eliminates the risk of virus presence, and of any other potential adventitious agents found in animal pancreas-derived trypsin. Recombinant human trypsin:The amino acid sequence is the same as the Human Trypsin 2.Stable:A sterile recombinant human trypsin lyophilized eliminates the contamination risks and decreases the chance of activity loss in the process of transport and storage.High purity:(1) Recombinant human trypsin provides increased specificity and eliminates contaminating activities found in lower purity enzymes.(2) No other contaminating proteases such as chymotrypsin or carboxypeptidase A... Read More |