| Description | One unit is defined as the amount of enzyme required to ligate 50% of HindIII fragments of λ DNA (5' DNA termini concentration of 0.12µM, 300µg/ml) in a total reaction volume of 20µl in 30 minutes at 16℃.Application：Ligation of dsDNA with sticky ends; nick repair of One unit is defined as the amount of enzyme required to ligate 50% of HindIII fragments of λ DNA (5' DNA termini concentration of 0.12µM, 300µg/ml) in a total reaction volume of 20µl in 30 minutes at 16℃.Application：Ligation of dsDNA with sticky ends; nick repair of dsDNA; cloning after the synthesis of second strand cDNA [2]. Source：Recombinant E. coli DNA ligase expressed in E. coli.Enzyme storage buffer：10mM Tris-HCl, 50mM KCl, 1mM DTT, 0.1mM EDTA, 200µg/ml BSA, 50% Glycerol (pH7.4, 25℃).Inactivation or inhibition：E. coli DNA Ligase can be inactivated by incubation at 65℃ for 20 minutes.Precautions：The ligation efficiency of this product for blunt-end fragments is extremely low. Use T4 DNA Ligase for blunt-end ligation.This product cannot be used for the ligation of ssDNA or RNA.This kit is for R&D only. Not for drug, household, or other uses.For your safety and health, please wear a lab coat and disposable gloves during the operation.Instructions for Use：1. Set up the reaction on ice as follows:ReagentVolumeFinal ConcentrationdsDNAxµlup to 0.25µg/µl10X Reaction Buffer2µl1XE. coli DNA Ligase (10U/µl)1µl0.5U/µlNuclease-free Water(17-x)µl-Total Volume20µl-Note 1: When multiple reactions are required, prepare a master mix including all reagents except the substrate DNA and then dispense to different nuclease-free PCR tubes. Finally, add substrate DNA to each tube.Note 2: E. coli DNA Ligase should be kept on ice during the experiment.2. Mix well by pipetting or vortex gently. Centrifuge briefly to collect liquid at the bottom of the PCR tube.3. Incubate at 16℃ for 30-60 minutes.4. After incubation, immediately heat inactivate the reaction at 65℃ for 20 minutes.5. Examine the reaction products by agarose gel or polypropylene gel electrophoresis. If DNA need to be recovered from agarose gel, we recommend using the DNA Gel Extraction Kit. To purify DNA from the enzyme digestion reactions, we recommend using the PCR Clean Up Kit/DNA Purification Kit. 6. For other applications, please refer to the relevant literature for E. coli DNA Ligase.FAQ:1. What is the difference between E. coli DNA Ligase and T4 DNA Ligase?Under the recommended conditions in the manual, E. coli DNA Ligase cannot ligate blunt-end DNA or RNA molecules [3].2. Can E. coli DNA Ligase be heat-inactivated?E. coli DNA Ligase can be inactivated by incubation at 65℃ for 20 minutes.3. How to choose the appropriate ligase or ligation kit?For rapid ligation of blunt- or sticky-end DNA fragments, the Rapid DNA Ligation Kit is recommended. T4 DNA Ligase is suitable for most DNA recombination reactions and can be used for sticky-end (10-minute ligation at room temperature) or blunt-end (2-hour or overnight ligation at room temperature) ligations. However, E. coli DNA Ligase is more selective for substrates and is recommended for sticky-end ligations. For ligation of ssDNA or RNA molecules, we recommend using the T4 RNA Ligase. References:1. Lehman IR. Science. 1974. 186(4166):790-7.2. Okayama H and Berg P. Mol Cell Biol. 1982. 2(2):161-70.3. Higgins NP and Cozzarelli NR. Methods Enzymol. 1979. 68:50-71... Read More | Protein Purity≥85% by SDS PAGEExtinction CoeffA280 nm = 0.974 at 1.0 mg/ml for pure C3bMolecular Weight185,000 Da (2 chains)General DescriptionCynomolgus monkey C3 (cyno C3) is purified from pooled normal cynomolgus monkey serum. C3 is central to the activation of all three pathways of Protein Purity≥85% by SDS PAGEExtinction CoeffA280 nm = 0.974 at 1.0 mg/ml for pure C3bMolecular Weight185,000 Da (2 chains)General DescriptionCynomolgus monkey C3 (cyno C3) is purified from pooled normal cynomolgus monkey serum. C3 is central to the activation of all three pathways of complement activation (Law, S.K.A. and Reid, K.B.M. (1995)). Initiation of each pathway generates proteolytic enzyme complexes (C3 convertases) which are bound to the target surface. These enzymes cleave a peptide bond in C3 releasing the anaphylatoxin C3a and activating C3b. For a brief time (~60 µs) this nascent C3b is capable of reacting with and covalently coupling to hydroxyl groups on the target surface. Carbohydrates are the favored target, but protein hydroxyls and amino groups also react. This process of tagging the target surface with C3b is called opsonization. The reactive site in nascent C3b is a thioester (Tack B.J., et al. (1980); Pangburn M.K. and MüllerEberhard H.J. (1980)) and C3b is linked to the target through a covalent ester bond (an amide bond is formed if C3b is attached to amino groups). Most of the C3 activated during complement activation never attaches to the surface because its thioester reacts with water forming fluid phase C3b which is rapidly inactivated by factors H and I forming iC3b. Surface-bound C3b is necessary in all three pathways for efficient activation of C5 and formation of C5b-9 complexes that lyse the target cell membrane. Surface-bound C3b and its breakdown products iC3b and C3d are recognized by numerous receptors on lymphoid and phagocytic cells which use the C3b ligand to stimulate antigen presentation to cells of the adaptive immune system. The end result is an expansion of target-specific B-cell and T-cell populations.Physical Characteristics & StructureCynomolgus monkey C3 is an uncharacterized protein. The calculated molecular weight based on its amino acid sequence is 184,926 daltons similar to that of human C3 (185,000 daltons). Like human C3, cyno C3 is composed of two disulfide-linked chains. Analysis of purified cyno C3 by SDS/polyacrylamide gel electrophoresis under non-reduced conditions shows the mobility of cyno C3 to be similar to that of human C3. Under reduced conditions, the migration of the alpha chain of cyno C3 is comparable to that of human C3 alpha chain (110,000 daltons) while the beta chain migrates slightly ahead of the human C3 beta chain (75,000daltons).The extinction coefficient of cyno C3 is calculated from its amino acid sequence using ProtParam and assumes all pairs of Cys residues form cystines (i.e. a pair of cystine molecules are joined by a disulfide bond). The theoretical pI value for cyno monkey C3 is 6.03. Employing immunoturbidimetric method the serum concentration of cyno C3 has been reported to be 1.27 mg/ml in males and 1.1 mg/ml in female monkeys (Park H-K et al., (2016)). FunctionThe biological functions of C3 are described above in the General Description and Physical Characteristics sections.GeneticsCynomolgus monkey C3 chromosome location 19. The NCBI Gene ID number for Cynomolgus monkey C3 is 102131458 and UniProt accession number is A0A2K5VPN1.Precautions/Toxicity/HazardsThis protein is purified from animal serum and therefore precautions appropriate for handling any animal blood-derived product must be used.ReferencesLaw, S.K.A. and Reid, K.B.M. (1995) Complement 2nd Edition (ISBN 0199633568) Oxford University Press, Oxford.Tack BF, Harrison RA, Janatova J, Thomas ML, Prahl JW. (1980) Evidence for presence of an internal thiolester bond in third component of human complement. Proc Natl Acad Sci U S A. 77:5764-8.Pangburn M.K. and Müller-Eberhard H.J. (1980) Relation of putative thioester bond in C3 to activation of the alternative pathway and the binding of C3b to biological targets of complement. J Exp Med. 152:1102-14.Park H-K, Cho J-W, Lee B-S, Park H, Han J-S, Yang M-J, Im W-J, Park D-Y, Kim W-J, Han SC, Kim Y-B. (2016) Reference values of clinical pathology parameters in cynomolgus monkeys (Macaca fascicularis) used in preclinical studies. Lab Anim Res. 32(2):79-86... Read More | Inquire | Purity>97% by SDS-PAGE and HPLC analyses.FunctionMay be involved in macrophage-mediated cellular proliferation. It is mitogenic for fibroblasts and smooth muscle but not endothelial cells. It is able to bind EGF receptors with higher affinity than EGF itself and is a far more potent mitogen for Purity>97% by SDS-PAGE and HPLC analyses.FunctionMay be involved in macrophage-mediated cellular proliferation. It is mitogenic for fibroblasts and smooth muscle but not endothelial cells. It is able to bind EGF receptors with higher affinity than EGF itself and is a far more potent mitogen for smooth muscle cells than EGF. Also acts as a diphtheria toxin receptor.Background:Human HB-EGF (Heparin-Binding EGF-like growth factor) is a 12-16 kDa member of the EGF family of peptide growth factors (1-3). Also known as the DTR (diphtheria toxin receptor), it is further classified as a group 2 ErbB ligand based on its ability to activate both the EGF/ErbB1 and ErbB4 receptors (4, 5). HB-EGF is synthesized as a 208 amino acid (aa) type I transmembrane preproprecursor (1, 6). It contains a 19 aa signal sequence, a 43 aa prosegment, an 86 aa mature region (aa 63-148), an 11 aa juxtamembrane cleavage peptide, a 24 aa transmembrane segment, and a 25 aa cytoplasmic tail (aa 184-208). As an integral membrane protein, HB-EGF is expressed as a 19-27 kDa protein in mammalian cells (7-9). The variability in molecular weight (MW) is attributed to heterogeneity in glycosylation and/or the utilization of multiple proteolytic cleavage sites during maturation. Mature HB-EGF is a soluble peptide that arises from proteolytic processing of the transmembrane form. It possesses an EGF-like domain between aa 104-144, and a heparin-binding motif between aa 93‑113. Although the aa range for "mature" HB-EGF is typically stated to be Asp63-Leu148, potential N-terminal start (cleavage) sites also exist at Gly32, Arg73, Val74, Ser77 and Ala82 (8, 10-12). Thus, differential processing (in part) likely accounts for the 16-23 kDa range in MW noted for mammalian-derived mature HB-EGF. Proteases suggested to contribute to HB-EGF processing include TACE, MMP-3 and -7, ADAM-17 and ADAM-12 (11, 13-16). When expressed recombinantly in E.coli, HB-EGF (aa 73-148) runs at 14 kDa in SDS-PAGE; when expressed in Baculovirus, HB-EGF (aa 63-148, 77-148 and 32-148) runs at 18 kDa, 15 kDa, and 19 kDa respectively (8, 12, 17). Over aa 63-148, human HB-EGF- shares 76% and 73% aa sequence identity with rat and mouse HB-EGF, respectively (1, 18). Cells known to express HB-EGF include bronchial epithelium (19), visceral and vascular smooth muscle (20, 21), CD4+ T cells (22), cardiac muscle (23), glomerular podocytes (24), keratinocytes (13) and IL-10-secreting regulatory macrophages (25). As noted earlier, HB-EGF is known to bind to both 170 kDa EGFR and 180 kDa ErbB4, and through heterodimerization, ErbB2 (13, 26). Activity associated with ErbB4 binding appears to be limited to non-mitogenic actions, while EGFR binding induces both mitogenic and non-mitogenic activity... Read More | Purity≥ 92% SDS-PAGEActual molecular weight 15&17kDaFunctionChemotactic factor that attracts monocytes and basophils but not neutrophils or eosinophils. Augments monocyte anti-tumor activity. Has been implicated in the pathogenesis of diseases characterized by monocytic infiltrates, like Purity≥ 92% SDS-PAGEActual molecular weight 15&17kDaFunctionChemotactic factor that attracts monocytes and basophils but not neutrophils or eosinophils. Augments monocyte anti-tumor activity. Has been implicated in the pathogenesis of diseases characterized by monocytic infiltrates, like psoriasis, rheumatoid arthritis or atherosclerosis. May be involved in the recruitment of monocytes into the arterial wall during the disease process of atherosclerosis... Read More |