| Description | EnzymoPure™M-MuLV Reverse Transcriptase (RNase H-) is an optimized Moloney Murine Leukemia Virus (M-MuLV) reverse transcriptase without ribonuclease H (RNase H) activity. It is a DNA polymerase that uses single stranded RNA or DNA as template to synthesize complementary DNA strands in the EnzymoPure™M-MuLV Reverse Transcriptase (RNase H-) is an optimized Moloney Murine Leukemia Virus (M-MuLV) reverse transcriptase without ribonuclease H (RNase H) activity. It is a DNA polymerase that uses single stranded RNA or DNA as template to synthesize complementary DNA strands in the presence of primers. Different from common M-MuLV reverse transcriptase, the EnzymoPure™M-MuLV Reverse Transcriptase (RNase H-) lacks RNase H activity, and does not degrade the RNA strand of an RNA-DNA hybrid, thus facilitating the synthesis of long cDNA. EnzymoPure™M-MuLV reverse transcriptase (RNase H-) is one of the most widely used reverse transcriptase for synthesizing cDNA.FeaturesApplication：First strand cDNA synthesis using total RNA or mRNA as template; DNA probe labeling; RNA analysis by primer extension; fluorescent probe labeling for DNA microarray analysis.Source：Recombinant protein expressed in E. coli. The RT M-MuLV reverse transcriptase (RNase H-) is encoded by the mutation-optimized pol gene encoding M-MuLV reverse transcriptase.Enzyme activity: One unit of the enzyme incorporates 1nmol of dTMP into a polynucleotide fraction in 10min at 37℃. Enzyme activity is assayed in 50mM Tris-HCl (pH8.3), 6mM MgCl2, 10mM DTT, 40mM KCl, 0.5mM dTTP, 0.4MBq/ml [3H]-dTTP, 0.4mM poly(A)•oligo(dT)12-18.Purity: Free from DNA endonuclease, DNA exonuclease, phosphoesterase and RNase.Storage buffer: 50mM Tris (pH8.3), 100mM NaCl, 1mM EDTA, 5mM DTT, 0.1% Triton X-100 and 50% glycerol.Reaction Buffer (5X): 250mM Tris (pH8.3 at 25℃), 250mM KCl, 20mM MgCl2, 50mM DTT.Inactivation or inhibition：RT M-MuLV Reverse Transcriptase (RNase H-) can be inactivated by incubation at 70℃ for 10 minutes, or inhibited by EDTA, EGTA, inorganic phosphates, pyrophosphates and polyamine.The concentration of this product is 200U/µl. When using a reaction volume of 20µl, this product is sufficient for 10 reactions.Precautions：Please refer to the instructions for reverse transcription of RNAs with high GC content.This product is for R&D only. Not for drug, household, or other uses.For your safety and health, please wear lab coat and disposable gloves during the operation.Instructions for Use：1. First-strand cDNA synthesisa. Set up the first-strand cDNA synthesis reaction in a nuclease-free PCR tube on ice or at room temperature as follows. RNase Inhibitor and dNTP mix can be purchased from. RNA Template (one of the three types of RNA)Total RNA0.01-5µgPoly(A) RNA/mRNA1-500ngSpecific RNA0.01pg-500ngPrimer (one of the three types of primers)Oligo(dT)18 Primer0.5µg (or 100pmol)Random Hexamer Primer0.2µg (or 100pmol)Gene-specific Primer15-25pmol(optional) For RNAs with high GC content or complex secondary structures, incubate the mixture of primer and template at 65ºC for 5 minutes, and immediately put it on ice to disrupt RNA secondary structures.DEPC-treated WaterTo 13.7µl*Reaction Buffer (5X)4µlRNase Inhibitor (40U/µl)0.5µl**dNTP Mix (25 mM each)0.8µl***RT M-MuLV Reverse 1µlTotal Volume20µl* ‘To 13.7µl’ means filling the mixture of template and primer to a total volume of 13.7µl with DEPC-treated water.** The volume of RNase Inhibitor may vary depending on the type of RNase Inhibitor used. If the volume of RNase Inhibitor is less than 0.5µl, adjust the volume of DEPC-treated water accordingly.*** The volume of dNTP mix varies depending on the concentration of dNTP stock. If the volume of dNTP is not 0.8µl, adjust the volume of DEPC-treated water accordingly.b. Mix the reaction by vortex or pipetting gently, centrifuge briefly to allow liquid to accumulate at the bottom of PCR tube.c. Incubate the reaction at 42ºC for 10-60min if Oligo(dT)18 or gene-specific primer is used. If random hexamer is used, carry out incubation at 25ºC for 10min, followed by incubation at 42℃ for 60 min. Note: For RNA template with high GC content or secondary structures, incubate the reaction at 45℃ for 60min.d. Stop the reverse transcription by incubating the reaction at 70℃ for 10min to inactivate the RT M-MuLV Reverse Transcriptase (RNase H-). Note: Heat-inactivation of reverse transcriptase is not recommended for long cDNA over 5kb, as this method may cause shearing of long cDNA fragments. In such a case, phenol-chloroform extraction or column purification can be considered.e. The reverse transcription products can be used directly for subsequent experiments such as PCR, or stored at -20℃ for future use. We recommend using 2µl reverse transcription products in a PCR reaction volume of 50µl.2. For other applications such as primer extension and probe labeling, please refer to reference related to M-MuLV reverse transcriptase (RNase H-)FAQ:1. The reverse transcription product of total RNA is invisible after electrophoresis.It is a normal phenomena, because the amount of RNA template is low, and the amount of reverse transcription products in different size is even lower. 2. No specific product can be amplified from the reverse transcription product.a. To exclude the problem of PCR reaction system or reverse transcription product, use gene-specific primers to amplify internal reference genes, such as actin and GAPDH. Reference genes can be amplified but not the target gene, indicating primers of target gene are not well designed or the expression of the target gene is too low to be detected. b. Inappropriate primer is used for reverse transcription. Random hexamer instead of Oligo(dT)18 should be used for the reverse transcription of bacterial total RNA which does not have poly(A) tails. Gene-specific primers used for reverse transcription must be well designed... Read More | Product Content:F665667Component5 mL40 mLStorageF665667A2×Flash PCR MasterMix (Dye) 5×1 mL 40×1 mL-20℃. Avoid freeze/thaw cycle.F665667BddH2O 5×1 mL40×1 mL-20℃. Avoid freeze/thaw cycle. Products Introduction This product is a premixed system consisting of a new Product Content:F665667Component5 mL40 mLStorageF665667A2×Flash PCR MasterMix (Dye) 5×1 mL 40×1 mL-20℃. Avoid freeze/thaw cycle.F665667BddH2O 5×1 mL40×1 mL-20℃. Avoid freeze/thaw cycle. Products Introduction This product is a premixed system consisting of a new high efficient fast DNA Polymerase, Mg2+, dNTPs, and PCR stabilizers and enhancers at 2× concentration. It is a new rapid DNA polymerase developed by CombiSigma with high amplification speed and stability. The extension speed is up to 5 s/kb, and the PCR can be completed in as little as 15 minutes, while longer fragments (>3 kb) or complex templates can be extended at a speed of 10-30 s/kb or a higher number of cycles. The unique MasterMix formula makes the whole reaction system very stable, while complex templates can be amplified effectively, and more than 98% of PCR amplification can be successful in one run. Simply add the DNA template and primers and top up with water to minimize human error, contamination and time.The dye (blue) has been added to the product and it is ready for electrophoretic detection at the end of the reaction. The PCR product is amplified with an 'A' base at the 3′ end and can therefore be used directly for T/A cloning and is suitable for use in the CombiVerge Seamless Cloning Kit, T4 Ligation Kit and sensory products.This product is mainly suitable for ultra-fast PCR, complex templates, complex secondary structures, gene cloning and large-scale genetic testing that requires high fidelity. quality control No exogenous nuclease activity was detected; no host residual DNA was detected by PCR; single-copy genes in various genomes could be amplified efficiently. UsageThe following is an example of a PCR reaction system and reaction conditions for amplifying a 1 kb fragment using human genomic DNA as a template, which should be improved and optimized according to the template, primer structure and size of the target fragment in actual operation.PCR reaction system Note: Please use the final concentration of 0.1-1.0 µM as a reference for setting the range of primer concentration. If the amplification efficiency is not high, the primer concentration can be increased; if a non-specific reaction occurs, the primer concentration can be decreased to optimize the reaction system.PCR reaction conditions Note: 1) Note: For simple templates, the pre-denaturation time can be controlled at 30 s-1 min, for complex templates such as bacterial fluids, the pre-denaturation time can be increased to 2 min.Optimization of parameter settings 1. Template DNA amount setting:Excessive amounts of template may result in non-specific amplification or smear. The recommended amount of template DNA in a 50 µl PCR reaction system is as follows:-Human genomic DNA 5 ng-500 ng-Escherichia coli genomic DNA 50 pg-100 ng-plasmid DNA 10 pg-1 ng 1. 30-35 number of cycles2. Primer concentration setting: The primer concentration can be set between 0.1 µM and 1.0 µM. A low primer concentration may result in low amplification products. Too high a primer concentration will inhibit specific amplification and may result in non-specific amplification.3. Annealing temperature setting: In general, the annealing temperature is 5℃ lower than the melting temperature of amplification primer Tm, so the annealing temperature can be lowered appropriately when the desired amplification efficiency cannot be obtained; the annealing temperature can be raised appropriately when non-specific reaction occurs. For complex templates, it is necessary to adjust the annealing temperature to achieve efficient amplification.4. Extension time setting: The extension time should be set according to the size of the amplified fragments. The following extension times are recommended: simple templates such as plasmids: 5-15 s/kb; regular genomes, cDNA templates: 10-15 s/kb; complex templates, crude templates: 20-30 s/kb; (the extension time should not be too short and should be at least 5 s/kb, but should not exceed 30 s/kb).5. Number of cycles: The number of cycles can be set according to the downstream application of the amplified product. If the number of cycles is too low, the amount of amplification will be insufficient; if the number of cycles is too high, the chance of mismatch will increase and the non-specific background will be serious. Therefore, the number of cycles should be minimized under the premise of ensuring the product yield... Read More | Amine-Reactive probe which passively diffuse into cells and it is nonfluorescent until the acetate groups are cleaved by intracellular esterases to yield the highly fluorescent, amine-reactive fluorophore. Upon reaction with amine-containing residues of intracellular proteins, these probes form dye Amine-Reactive probe which passively diffuse into cells and it is nonfluorescent until the acetate groups are cleaved by intracellular esterases to yield the highly fluorescent, amine-reactive fluorophore. Upon reaction with amine-containing residues of intracellular proteins, these probes form dye protein adducts that are well retained in cells as they move and divide during embryonic development.A Non-fluorescent cell permeant amine-reactive probe for long term tracing of cell... Read More | Extinction Coeff.A280 nm = 1.0 at 1.0 mg/mLSpecificityMonospecific for Factor B in human plasma and serumGeneral DescriptionProduct is whole polyclonal antiserum from goats immunized with highly purified human complement protein. Product is not a purified IgG fraction. Goats are maintained in FDA Extinction Coeff.A280 nm = 1.0 at 1.0 mg/mLSpecificityMonospecific for Factor B in human plasma and serumGeneral DescriptionProduct is whole polyclonal antiserum from goats immunized with highly purified human complement protein. Product is not a purified IgG fraction. Goats are maintained in FDA certified facilities.Physical Characteristics & StructureAntibodies present in the antisera are primarily IgGApplicationsWestern Blots: Effective at dilutions 1/4,000 to 1/8,000 depending on conditions.Most effective against non-reduced antigen.ELISA: Effective at dilutions 1/8,000 to 1/16,000 depending on conditions.Immunodiffusion: Effective against NHS and plasma at 1/16 dilution... Read More | Biochemical Test:SDS-PAGE (purity > 80%); Western blot with patient sample.Calculated Isoelectric Point:pH 4.19 |