| Description | ApplicationIt is used in the research and development of enzymatic glycosylated albumin reagents and mass formulation.Enzymatic propertiesSource: MicroorganismEnzymology Committee Number: EC1.5.3Molecular weight: 55kDa (SDS-PAGE)Isoelectric point: 6Km value: 5.0×10 ⁻⁴ M (Fructosyl-ApplicationIt is used in the research and development of enzymatic glycosylated albumin reagents and mass formulation.Enzymatic propertiesSource: MicroorganismEnzymology Committee Number: EC1.5.3Molecular weight: 55kDa (SDS-PAGE)Isoelectric point: 6Km value: 5.0×10 ⁻⁴ M (Fructosyl-Ala)Inhibitors: Hg ²⁺, Pb ²⁺ Optimal pH: 7.7 Figure 1Optimum temperature: 42℃ Figure 2pH stability: 5.0-9.5 (25℃, 16h) Figure 3Thermal stability: Stable below 40℃ (pH8.0, 30min) Figure 4Stability: -25 ~ -15℃ standing store for 12 monthsMore than 90% activity Figure 5Protective agent: glycerin, trehaloseAssay method for activity1. Principle 2. Definition of enzyme activityUnit enzyme activity is defined as the amount of enzyme required to catalyze the production of 1µmol H2O2 per minute under the following conditions.3. Reagent preparationReagent I: 1M potassium phosphate buffer, pH8.0Reagent II: 1kU/mL PODReagent III: 50mM TOOS solutionReagent IV: 50mM 4-AA solutionReagent V: 200mM Glycated alanineEnzyme diluent: 20mM Tris-HCl, pH8.0Prepare the reaction mixture as follows:Reagent I: 10mLReagent II: 0.1mLReagent III: 1mLReagent IV: 1mLReagent V: 10mLDouble steam water set volume to 100mL4. Operation procedure4.1 Add 980µL reaction mixture into 1mL colorimetric dish.4.2 Incubate at 37°C for 5 minutes.4.3 Add 20 µL of enzyme solution to be tested to the reaction mixture.4.4 Reaction at 37°C, the absorbance change (∆As) of the sample within 1min is detected by spectrophotometer at 555nm.* Blank control measurement method: Use 20 µL of enzyme dilution solution instead of the enzyme solution to be tested, and measure the absorbance change (ΔAb) of the sample within 1 minute.∆A=∆As-∆Ab5. Vitality computingVt: Total volume of reaction liquid (1.0 mL);Vs: Enzyme liquid volume (0.02 mL);t: Reaction time (1 min);df: Dilution ratio;C: Enzyme concentration (mg/mL);1.0: Optical path length (cm);1/2: 1 mole hydrogen peroxide to generate 1/2 mole quinone imide dye;39.2: Under standard reaction conditions, the millimolar absorption coefficient of the color group at 555nm (cm² /µmol)... Read More | Inquire | 1、Product attributeShelf life: 24 monthsReaction time：long (up to 45 minutes) at 20-37°CLot-to-lot variation：<10%Boiling point : 100℃pH-Value (at 20 °C): 9.0-9.8 Density (20℃) : 1.0302 g/cm³Water solubility: easily solubleAppearance: colourless to 1、Product attributeShelf life: 24 monthsReaction time：long (up to 45 minutes) at 20-37°CLot-to-lot variation：<10%Boiling point : 100℃pH-Value (at 20 °C): 9.0-9.8 Density (20℃) : 1.0302 g/cm³Water solubility: easily solubleAppearance: colourless to light yellow liquidOdour: odourlessIncubation temperature: 20-37 °CLight sensitiveHeat sensitive 2、Requirements for storage rooms and vessels1.Keep container tightly closed.2.Keep cool. protected from light3. Do not store together with: Oxidizing agent. 4. Contaminated or leaked out substrate solution from damaged bottles should not be used anymore and has to be destroyed.5. Use isolated containers with some cool bags for transport.6. Spontaneous decay will increase the background. If stored at room temperature, the velocity of the decay will increase. Thus, both storage and transport at room temperature should be avoided. Nevertheless, the activity of the solution is not affected by storage at room temperature. The solution still works beyond the expiry date, but some applications, especially those including visual evaluation, may be hampered by increased background. 3、Effective Components and Principle of FunctionIn different buffer solutions (pH = 9.5), with supplementation if required, the effective componentpara nitrophenyl phosphate (pNPP) is dissolved. Alkaline Phosphatase transfers the phosphate residue to an acceptor. Under alkaline conditions a yellow colour occurs, resulting from the formed nitrophenol. 4、Biosafety informationThis mixture is not classified as hazardous in accordance with Regulation (EC) No 1272/2008； 5、Advantage1. Signal yield comparable to competitor ready-to-use solutions2. Broad measurement range3. Very low background signals4. Very low blank drift during long-term storage (<0.15 AU within 24 months)5. High colour stability after reaction stop with this product and other commonly used stopping solutions 6、Instruction for usageFor bottling consider the following instructions:• Work in a dust free and darkened room.• Keep the solution as cool as possible.• Avoid contact of the solutions with any metal parts• Clean all instruments and vessels very extensively.• Wear powder-free gloves during bottling.• Close the bottles immediately to minimize the influence of light and dust.• Use clean bottles that are impermeable to light made from HDPE or PP. 7、 General Instructions for the Use in Blotting Systems Only qualified laboratory staff, who are familiar with the basics of immunological methods, are allowed to use these solutions.The substrate solutions can be used in qualitative and quantitative ELISA procedures.When using 96-well microtiter plates, adding 100 µL of substrate per well after incubation and washing is recommended. After substrate incubation the reaction can be stopped and the photometric measurement can be carried out. Using higher incubation temperatures (37° C) may shorten the incubation time. The reaction can be stopped by using the special developed solution stop. The use of other commercially available stop solutions cannot safely exclude a further increase of the signal. Addition of a stopping solution does not change the general shape of the spectrum. The unstopped and the stopped solution should be measured at 405 nm and the background correction: should be measured at 620 nm... Read More | Inquire | Vabicaserin hydrochloride is a 5-hydroxytryptamine 2C ( 5-HT 2C ) receptor -selective agonist with an EC 50 of 8 nM.In VitroVabicaserin displaces 125 I-(2,5-dimethoxy)phenylisopropylamine binding from human 5-HT 2C receptor sites in Chinese hamster ovary cell membranes with a K i value of 3 nM and Vabicaserin hydrochloride is a 5-hydroxytryptamine 2C ( 5-HT 2C ) receptor -selective agonist with an EC 50 of 8 nM.In VitroVabicaserin displaces 125 I-(2,5-dimethoxy)phenylisopropylamine binding from human 5-HT 2C receptor sites in Chinese hamster ovary cell membranes with a K i value of 3 nM and is >50-fold selective over a number of serotonergic, noradrenergic, and dopaminergic receptors. Binding affinity determined for the human 5-HT 2B receptor subtype using [ 3 H]5HT is 14 nM. Vabicaserin is a potent and full agonist (EC 50, 8 nM; E max, 100%) in stimulating 5-HT 2C receptor-coupled calcium mobilization and exhibits 5-HT 2A receptor antagonism and 5-HT 2B antagonist or partial agonist activity in transfected cells, depending on the level of receptor expression. Vabicaserin exhibits lower affinity at the 5-HT 2C antagonist binding site (22 nM) labeled with [ 3 H]mesulergine. Additional binding studies indicate that Vabicaserin possesses affinity for the 5-HT 2B and 5-HT 1A receptors with K i values of 14 and 112 nM, respectively. MCE has not independently confirmed the accuracy of these methods. They are for reference only.In VivoAfter a single oral dose of [ 14 C]Vabicaserin at 50, 5, and 15 mg/kg, unchanged drug represents less than 19, 20, and 35% of total plasma radioactivity at all the time points examined in mice, rats, and dogs, respectively. The carbamoyl glucuronide (CG) represents approximately 7 to 36% of plasma radioactivity in mice and 2 to 28% of plasma radioactivity in dogs but is not detected in rat plasma after the single [ 14 C]Vabicaserin dose. However, the CG is observed in rat plasma after multiple-dose administration of Vabicaserin at higher doses, and the CG is approximately 20 times less than Vabicaserin based on steady-state AUC 0-24 values. The estimated plasma AUC 0-24 ratios of CG to the parent drug are 1.5 and 1.7 in mice and dogs after the single [ 14 C]Vabicaserin dose, respectively. The plasma AUC 0-24 ratios for the CG to Vabicaserin at steady state with doses used for safety assessment are less for mice (0.2-0.6) and slightly higher for dogs (1.8-4.0) compared with the single dose values. The CG is detected in dog urine in similar amounts to the parent drug, although it is not detected in mouse or rat urine after the single [ 14 C]Vabicaserin dose. Radioactivity in a 0- to 24-h bile collection from rats receiving a 5 mg/kg [ 14 C]Vabicaserin dose accounts for 19 and 24% of the administered dose in males and females, respectively. Although the CG is not detected in urine or feces of rats after a single oral administration, it represents an average of up to 30% of biliary radioactivity in male rats and 15% in female rats. In monkeys after a single oral 25-mg/kg dose of Vabicaserin, the plasma concentrations of the CG exceeded those of Vabicaserin at all the time points (2-24 h) postdose, although the amount of CG relative to Vabicaserin decreased by 24 h postdose, with ratios of 17.5 at 2 h and 1.7 at 24 h. The CG to Vabicaserin AUC 0-24 ratio of 12:1 indicates that the CG is a major metabolite in monkeys. MCE has not independently confirmed the accuracy of these methods. They are for reference only.Animal administrationMice and Rats For metabolism studies in mice, rats, and dogs, radiolabeled doses are used. Male and female CD-1 mice and Sprague-Dawley rats are used. The dose vehicle for mice and rats contained 2% (w/w) Tween 80 and 0.5% methylcellulose in water. Nonfasted male and female mice weighing from 27.8 to 33.8 g at the time of dosing are given a single 50-mg/kg (∼300 µCi/kg) dose of Vabicaserin at a volume of 20 mL/kg via intragastric gavage. Mice are kept in metabolic cages in groups of five. Nonfasted male rats weighing from 318 to 345 g and female rats weighing from 227 to 255 g at the time of dosing are given a single 5-mg/kg (∼300 µCi/kg) dose of Vabicaserin at a volume of 2.5 mL/kg via intragastric gavage. Four bile duct-cannulated male rats weighing from 387 to 411 g and four bile duct-cannulated female rats weighing from 291 to 325 g at the time of dosing are nonfasted and are given a single 5-mg/kg (323 µCi/kg) dose of Vabicaserin at a volume of 5.0 mL/kg via intragastric gavage. Rats are kept individually in metabolism cages. Dogs Four male beagle dogs, weighing from 7.6 to 9.8 kg at the time of dosing, are from an in-house colony. Approximately 11 mg of [ 14 C]Vabicaserin hydrochloride and 940 mg of nonlabeled Vabicaserin hydrochloride are dissolved in methanol and then evaporated under a nitrogen stream to dryness. Capsules (number 2) are filled with accurate amounts (126.7-138.1 mg) of the mixed drug substance according to animal weights to give a dosage of 15 mg/kg (39 µCi/kg). The filled gelatin capsules are then enteric-coated manually. Each dog is given one enteric-coated capsule containing [ 14 C]Vabicaserin as the hydrochloride salt. Animals are fed 2 h before dosing and are housed individually in metabolic cages. Monkey Four male cynomolgus monkeys, weighing from 5.4 to 9.6 kg at the time of dosing, are from an in-house colony. Nonfasted monkeys are given a single 25-mg/kg dose of nonradiolabeled Vabicaserin at a volume of 2 mL/kg via intragastric gavage. The vehicle is the same as used in mice and rats. Animals are housed individually in metabolic cages. aladdin has not independently confirmed the accuracy of these methods. They are for reference only.IC50& Target:5-HT 2C Receptor 8 nM (EC 50 )... Read More |