| Description | DCAF11 Human Pre-designed siRNA Set A contains three designed siRNAs for DCAF11 gene (Human), as well as a negative control, a positive control, and a FAM-labeled negative control. Components DCAF11 siRNA-1: 5 nmol (HPLC) DCAF11 siRNA-2: 5 nmol (HPLC) DCAF11 siRNA-3: 5 nmol (HPLC) siRNA Negative DCAF11 Human Pre-designed siRNA Set A contains three designed siRNAs for DCAF11 gene (Human), as well as a negative control, a positive control, and a FAM-labeled negative control. Components DCAF11 siRNA-1: 5 nmol (HPLC) DCAF11 siRNA-2: 5 nmol (HPLC) DCAF11 siRNA-3: 5 nmol (HPLC) siRNA Negative Control: 5 nmol (HPLC) FAM-labeled siRNA Negative Control: 5 nmol (HPLC) GAPDH siRNA Positive Control:5 nmol (HPLC)... Read More | Product Content:F665667Component5 mL40 mLStorageF665667A2×Flash PCR MasterMix (Dye) 5×1 mL 40×1 mL-20℃. Avoid freeze/thaw cycle.F665667BddH2O 5×1 mL40×1 mL-20℃. Avoid freeze/thaw cycle. Products Introduction This product is a premixed system consisting of a new Product Content:F665667Component5 mL40 mLStorageF665667A2×Flash PCR MasterMix (Dye) 5×1 mL 40×1 mL-20℃. Avoid freeze/thaw cycle.F665667BddH2O 5×1 mL40×1 mL-20℃. Avoid freeze/thaw cycle. Products Introduction This product is a premixed system consisting of a new high efficient fast DNA Polymerase, Mg2+, dNTPs, and PCR stabilizers and enhancers at 2× concentration. It is a new rapid DNA polymerase developed by CombiSigma with high amplification speed and stability. The extension speed is up to 5 s/kb, and the PCR can be completed in as little as 15 minutes, while longer fragments (>3 kb) or complex templates can be extended at a speed of 10-30 s/kb or a higher number of cycles. The unique MasterMix formula makes the whole reaction system very stable, while complex templates can be amplified effectively, and more than 98% of PCR amplification can be successful in one run. Simply add the DNA template and primers and top up with water to minimize human error, contamination and time.The dye (blue) has been added to the product and it is ready for electrophoretic detection at the end of the reaction. The PCR product is amplified with an 'A' base at the 3′ end and can therefore be used directly for T/A cloning and is suitable for use in the CombiVerge Seamless Cloning Kit, T4 Ligation Kit and sensory products.This product is mainly suitable for ultra-fast PCR, complex templates, complex secondary structures, gene cloning and large-scale genetic testing that requires high fidelity. quality control No exogenous nuclease activity was detected; no host residual DNA was detected by PCR; single-copy genes in various genomes could be amplified efficiently. UsageThe following is an example of a PCR reaction system and reaction conditions for amplifying a 1 kb fragment using human genomic DNA as a template, which should be improved and optimized according to the template, primer structure and size of the target fragment in actual operation.PCR reaction system Note: Please use the final concentration of 0.1-1.0 µM as a reference for setting the range of primer concentration. If the amplification efficiency is not high, the primer concentration can be increased; if a non-specific reaction occurs, the primer concentration can be decreased to optimize the reaction system.PCR reaction conditions Note: 1) Note: For simple templates, the pre-denaturation time can be controlled at 30 s-1 min, for complex templates such as bacterial fluids, the pre-denaturation time can be increased to 2 min.Optimization of parameter settings 1. Template DNA amount setting:Excessive amounts of template may result in non-specific amplification or smear. The recommended amount of template DNA in a 50 µl PCR reaction system is as follows:-Human genomic DNA 5 ng-500 ng-Escherichia coli genomic DNA 50 pg-100 ng-plasmid DNA 10 pg-1 ng 1. 30-35 number of cycles2. Primer concentration setting: The primer concentration can be set between 0.1 µM and 1.0 µM. A low primer concentration may result in low amplification products. Too high a primer concentration will inhibit specific amplification and may result in non-specific amplification.3. Annealing temperature setting: In general, the annealing temperature is 5℃ lower than the melting temperature of amplification primer Tm, so the annealing temperature can be lowered appropriately when the desired amplification efficiency cannot be obtained; the annealing temperature can be raised appropriately when non-specific reaction occurs. For complex templates, it is necessary to adjust the annealing temperature to achieve efficient amplification.4. Extension time setting: The extension time should be set according to the size of the amplified fragments. The following extension times are recommended: simple templates such as plasmids: 5-15 s/kb; regular genomes, cDNA templates: 10-15 s/kb; complex templates, crude templates: 20-30 s/kb; (the extension time should not be too short and should be at least 5 s/kb, but should not exceed 30 s/kb).5. Number of cycles: The number of cycles can be set according to the downstream application of the amplified product. If the number of cycles is too low, the amount of amplification will be insufficient; if the number of cycles is too high, the chance of mismatch will increase and the non-specific background will be serious. Therefore, the number of cycles should be minimized under the premise of ensuring the product yield... Read More | C1q separated from C1r and C1s and from other stabilizing proteins tends to aggregate easily. Because it was isolated and studied in numerous research laboratories, many buffers have been used to stabilize concentrated C1q and prevent aggregation. About half of the scientists prefer high salt and C1q separated from C1r and C1s and from other stabilizing proteins tends to aggregate easily. Because it was isolated and studied in numerous research laboratories, many buffers have been used to stabilize concentrated C1q and prevent aggregation. About half of the scientists prefer high salt and the other prefer 40% glycerol in the storage buffer.C1q is purified from pooled normal human plasma. C1q is part of the C1 complex and this complex is the first complement component in the cascade referred to as the classical pathway of complement. C1 is actually a non-covalent assembly of three different proteins (C1q, C1r, and C1s) bound together in a calcium-dependent complex. C1q has six extended arms with domains at the end of each arm that bind to the Fc domains of immunoglobulins. When antibodies bind to antigens forming immune complexes they cluster allowing two or more of its six arms of C1q to bind to the Fc domains of antibodies such as IgG or IgM. The binding of multiple arms to immune complexes causes the two C1r proteins in the complex (protease zymogens) to auto-activate producing two C1r proteases that cleave and activate the two C1s protease zymogens in the complex. Activated C1s cleaves complement component C4 releasing C4a and initiating covalent attachment of C4b to the activating surface. Activated C1s also cleaves C2 and the larger fragment of C2 binds to the surface-attached C4b forming C4b,C2a which is the C3/C5 convertase of the classical pathway.Extinction Coeff.A₂₈₀ nm = 0.68 at 1.0 mg/ml for pure C1q Molecular weight:410,000 Da (18 chains)Preservative:None, 0.22 µm filtered.Source:Normal human serum (shown by certified tests to be negative for HBsAg, HTLV-I/II, STS, and for antibodies to HCV, HIV-1 and HIV-II).Physical Characteristics & StructureC1q is a high molecular weight complex of 18 polypeptide chains. Each of the six arms of C1q contains three chains, an A chain (26,000 daltons), a B chain (25,000 daltons) and a C chain (24,000 daltons). The three chains are coiled into a collagen-like triple helix over approximately half their length. Half of this collagen region forms a central core where all 18 chains come together. The chains are joined in this core by disulfides in the pattern A-B and C-C. There is a bend in the center of the collagen region allowing the arms to extend away from each other. Globular heads at the far ends of the collagen arms possess binding sites for Fc domains of immunoglobulins. C1 complex is composed of one C1q molecule (410,000 daltons), two C1r molecules (92,000 daltons) and two C1s molecules (86,000 daltons). The complex is stable in the presence of calcium, but easily dissociates if calcium is removed. When C1 is activated the C1r and C1s subunits are each cleaved into two chain molecules due to proteolytic activation. Thus, the SDS gel pattern of C1 is very complex. Function The biological functions of C1q are described above in the General Description and Physical Characteristics sections. C1q functional activity may be assayed using C1q-depleted serum and EA cells. These assays are extremely sensitive to C1q typically yielding 50% lysis with less than 2 ng C1q in assays measuring the lysis of EA cells. AssaysThe unit of classical pathway activity is the CH50. A similar unit, the C1qH50, is used to quantitate the activity of C1q. A C1qH50 unit is the amount of functional C1q needed to lyse 50% of 3×10^7 EA cells (antibody-sensitized sheep erythrocytes) when that amount of C1q is incubated with 5-20 µL of C1q-Dpl in GVB++ in a total volume of 500 µL for 30 min at 37℃. This amount of C1q indicates the sensitivity of the assay for C1q which is typically about 1 ng C1q with 10 µL C1q-Dpl. See the Certificate of Analysis for lot specific values.ApplicationsC1q is used to coat ELISA plates to capture and quantitate immune complexes in clinical samples. A number of commercial companies sell diagnostic kits for immune complex detection and quantitation. These kits are based on the ability of C1q to bind well to immune complexes, but to not bind significantly to monomeric immunoglobulins. GeneticsThe EMBL/Genbank cDNA accession numbers are: C1q A chain (P02745), C1q B chain (P02746), and C1q C chain (P02747). The genes for C1q chains A, B and C are all located on chromosome 1p in the order A-C-B. DeficienciesDeficiencies of each of the three components of C1 have been found. Patients lacking C1q generally have immune-complex-mediated renal disease and skin lesions. Like all patients lacking early classical pathway components C1q deficient individuals are prone to systemic lupus erythrematosis (SLE) and recurrent pyogenic infections. They lack classical pathway function and may or may not exhibit C1q antigen in blood.DiseasesSee section titled Deficiencies above. Precautions/Toxicity/HazardsThis protein is purified from human serum and therefore precautions appropriate for handling any blood-derived product must be used even though the source was shown by certified tests to be negative for HBsAg, HTLV-I/II, STS, and for antibodies to HCV, HIV-1 and HIV-II... Read More | Acid phosphatase is an esterase with broad activity at an optimal pH below 7.0. There are three isozymes, EI, EII, and EIII of similar molecular weight (55 kDa± 5 kDa). Their optimum pH's are 5.5, 4.5, and 4.0 respectively. Acid phosphatase activity was observed by Teller Aladdin Library Acid phosphatase is an esterase with broad activity at an optimal pH below 7.0. There are three isozymes, EI, EII, and EIII of similar molecular weight (55 kDa± 5 kDa). Their optimum pH's are 5.5, 4.5, and 4.0 respectively. Acid phosphatase activity was observed by Teller Aladdin Library Archives in 1954 in preparations of a wheat germ lipase described by Singer JBC, 174, 11, in 1948. Equivalent commercial preparations have been distributed labeled as lipase and acid phosphatase thus generating some confusion. Subsequent work has confirmed that the non-specific esterase activity of the wheat germ preparation may be measured both as lipase (triacetin as substrate) and phosphatase. The enzyme assay is based on the work of Brandenberger and Hanson (Helv. Chim. Acta, 36, 900, 1953) and Hofstee ( Arch. Biochem. Biophys., 51, 239, 1954).Acid phosphatase (APase) non-specifically catalyzes the hydrolysis of monoesters and anhydrides of phosphoric acid to produce inorganic phosphate. It is used to study the production, transport, and recycling of phosphate and the metabolic and energy transduction processes of the cell.Characteristics of Acid Phosphatase from Wheat Germ:Molecular weight: 55,000 ± 5,000 (Verjee 1969).Composition: Three isozymes of closely similar molecular weights have been reported by Verjee (1969): EI, EII, and EIII. See also Brouillard and Ouellet (1965).Optimal pH: EI - 5.5, EII - 4.5, and EIII - 4.0. (Verjee 1969).Specificity: The enzyme has a broad esterase activity. See Joyce and Grisolia (1960). It shows highest activity for pyrophosphate.Inhibitors: Fluoride, molybdate and orthophosphate (Verjee 1969)... Read More | Purity>98% by SDS-PAGE and HPLC analyses.FunctionChemoattractant for blood monocytes, memory T-helper cells and eosinophils. Causes the release of histamine from basophils and activates eosinophils. Binds to CCR1, CCR3, CCR4 and CCR5. One of the major HIV-suppressive factors produced by CD8+ T-Purity>98% by SDS-PAGE and HPLC analyses.FunctionChemoattractant for blood monocytes, memory T-helper cells and eosinophils. Causes the release of histamine from basophils and activates eosinophils. Binds to CCR1, CCR3, CCR4 and CCR5. One of the major HIV-suppressive factors produced by CD8+ T-cells. Recombinant RANTES protein induces a dose-dependent inhibition of different strains of HIV-1, HIV-2, and simian immunodeficiency virus (SIV). The processed form RANTES(3-68) acts as a natural chemotaxis inhibitor and is a more potent inhibitor of HIV-1-infection. The second processed form RANTES(4-68) exhibits reduced chemotactic and HIV-suppressive activity compared with RANTES(1-68) and RANTES(3-68) and is generated by an unidentified enzyme associated with monocytes and neutrophils... Read More |