| Description | HSP90AA1 Human Pre-designed siRNA Set A contains three designed siRNAs for HSP90AA1 gene (Human), as well as a negative control, a positive control, and a FAM-labeled negative control. Components HSP90AA1 siRNA-1: 5 nmol (HPLC) HSP90AA1 siRNA-2: 5 nmol (HPLC) HSP90AA1 siRNA-3: 5 nmol (HPLC) siRNA HSP90AA1 Human Pre-designed siRNA Set A contains three designed siRNAs for HSP90AA1 gene (Human), as well as a negative control, a positive control, and a FAM-labeled negative control. Components HSP90AA1 siRNA-1: 5 nmol (HPLC) HSP90AA1 siRNA-2: 5 nmol (HPLC) HSP90AA1 siRNA-3: 5 nmol (HPLC) siRNA Negative Control: 5 nmol (HPLC) FAM-labeled siRNA Negative Control: 5 nmol (HPLC) GAPDH siRNA Positive Control:5 nmol (HPLC)... Read More | Inquire | Inquire | Product introduction：Used to isolate lymphocytes from human organsMatters needing attention：1. samples, reagents and experimental environment in the whole process shall be carried out at 20 ± 2 ℃. In order to obtain the best experimental results, it is best to carry out the Product introduction：Used to isolate lymphocytes from human organsMatters needing attention：1. samples, reagents and experimental environment in the whole process shall be carried out at 20 ± 2 ℃. In order to obtain the best experimental results, it is best to carry out the experiment within 2 h of sampling. The longer the sample is stored, the worse the cell separation effect is. The separation effect is even worse after the sample is placed for more than 6 h, or even cannot achieve the purpose of separation. 2. in this experiment, it is better not to use plastic products with high polymerization materials (such as polystyrene), but use non-static, low static ionization heart tubes and glass products without alkali treatment, because the electrostatic effect will lead to cell adhesion, and the surface of alkali treated glass will become rough, which will affect the effect of cell separation. 3. aspirating too many lymphocyte layers and separation liquid layers will cause the granulocytes at the junction of separation liquid to be aspirated, thus increasing the number of mixed granulocytes. 4. when the amount of separating solution is greater than that of tissue single cell suspension sample, the separation effect is better.Scope of application：Lymphocyte isolation... Read More | Inorganic pyrophosphates are inevitably produced in the process of mRNA transcription in vitro. These substances have a great inhibitory effect on transcription. Inorganic pyrophosphatase (PPase) can hydrolyze the inorganic pyrophosphates produced in nucleic acid amplification experiments, promote Inorganic pyrophosphates are inevitably produced in the process of mRNA transcription in vitro. These substances have a great inhibitory effect on transcription. Inorganic pyrophosphatase (PPase) can hydrolyze the inorganic pyrophosphates produced in nucleic acid amplification experiments, promote the shift of reaction equilibrium to the product generation end, and increase the amount of products.The molecular weight of PPase (pyrophosphatase, inorganic, inorganic pyrophosphatase) is about 63kd, which can catalyze the hydrolysis of inorganic pyrophosphate to produce orthophosphate: P2O74_+H2O+PPase→2HPO42_. In the nucleic acid amplification experiment, PPase can hydrolyze the inorganic pyrophosphate generated with the reaction to avoid its inhibition on the reaction system. The removal of pyrophosphate can shift the reaction equilibrium to the product generation end.This product is a GMP level recombinant inorganic pyrophosphatase (yeast source) expressed by large-scale fermentation of E. coli. It is produced with raw and auxiliary materials of medicinal specifications, and the host protein residue and nucleic acid residue are strictly controlled. The product production and quality management procedures in line with GMP specifications ensure that the production process and all raw and auxiliary materials can be traced.Quality requirements project standard appearance Clear liquid Visible foreign matter Compliance with regulations PH value 7.5±8.5 activity 98U/ml-102U/ml purity ≥95% Endonuclease residues Degradation of substrate shall not exceed 10% Exonuclease residues Degradation of substrate shall not exceed 10% RNase residue Degradation of substrate shall not exceed 10% Bacterial endotoxin content ≤10EU/ml Exogenous DNA residue ≤100pg/mg Host protein residue ≤50ppm Mycoplasma detection negative Heavy metal residues ≤10ppm Follow the following specifications1. ISO 9001:2015, certified facility。2. GMP appendix - cell therapy products State Drug Administration.3. general introduction to human gene therapy - Chinese Pharmacopoeia 2020, National Pharmacopoeia Committee.4. USP chapter <1043>, adjuvant materials for cell, gene, and tissue engineered products.5. USP chapter <92>, growth factors and cytokines used in cell therapy manufacturing.6. Ph. Eur. General chapter 5.2.12, raw materials of biological origin for the production of cell-based and gene therapy medical products.Product features1. hydrolyze inorganic pyrophosphate.2. DNA synthesis: significantly enhance DNA replication ability.3. RNA synthesis: increase RNA production in in vitro transcription reaction.4. The optimal reaction temperature is 25℃, and the enzyme can be inactivated at 65℃ for 10min.Product usage1. optimize RNA transcription: improve the RNA yield of in vitro transcription reaction.2. remove PPI contamination from reagents for SNP genotyping by pyrophosphate assay.3. promote the synthesis of protein, RNA and DNA.4. catalyze the reaction of PPI + H2O → 2pi.5. ssr-pcr optimization：Improve efficiency and increase DNA production.Activity definitionCatalytic inorganic pyrophosphate formation 1 per minute under standard reaction conditions µ The amount of enzyme required for mol phosphate was defined as 1 active unit.Preservation system20 mM Tris-HCl; 100 mM NaCl; 1 mM DTT; 0.1 mM EDTA; 50% (v/v) Glycerol; pH 8.0。 Storage temperature-20±5 ℃。Matters needing attention1. the enzyme has activity in various reaction buffers. Generally, the enzyme can be directly added in HDA, lamp and other experiments.2. the dosage of the enzyme needs to be optimized in different experiments, usually adjusted at the concentration of 0.05~1u/ml.3. the optimum reaction temperature of the enzyme was 25 ℃, and it was active at 16~37 ℃, and the enzyme could be inactivated at 65 ℃ for 10min.4. cofactor: mg2+ is necessary for enzyme activity... Read More |