| Description | DOK7 Human Pre-designed siRNA Set A contains three designed siRNAs for DOK7 gene (Human), as well as a negative control, a positive control, and a FAM-labeled negative control. Components DOK7 siRNA-1: 5 nmol (HPLC) DOK7 siRNA-2: 5 nmol (HPLC) DOK7 siRNA-3: 5 nmol (HPLC) siRNA Negative Control: 5 DOK7 Human Pre-designed siRNA Set A contains three designed siRNAs for DOK7 gene (Human), as well as a negative control, a positive control, and a FAM-labeled negative control. Components DOK7 siRNA-1: 5 nmol (HPLC) DOK7 siRNA-2: 5 nmol (HPLC) DOK7 siRNA-3: 5 nmol (HPLC) siRNA Negative Control: 5 nmol (HPLC) FAM-labeled siRNA Negative Control: 5 nmol (HPLC) GAPDH siRNA Positive Control:5 nmol (HPLC)... Read More | Product Content:F665667Component5 mL40 mLStorageF665667A2×Flash PCR MasterMix (Dye) 5×1 mL 40×1 mL-20℃. Avoid freeze/thaw cycle.F665667BddH2O 5×1 mL40×1 mL-20℃. Avoid freeze/thaw cycle. Products Introduction This product is a premixed system consisting of a new Product Content:F665667Component5 mL40 mLStorageF665667A2×Flash PCR MasterMix (Dye) 5×1 mL 40×1 mL-20℃. Avoid freeze/thaw cycle.F665667BddH2O 5×1 mL40×1 mL-20℃. Avoid freeze/thaw cycle. Products Introduction This product is a premixed system consisting of a new high efficient fast DNA Polymerase, Mg2+, dNTPs, and PCR stabilizers and enhancers at 2× concentration. It is a new rapid DNA polymerase developed by CombiSigma with high amplification speed and stability. The extension speed is up to 5 s/kb, and the PCR can be completed in as little as 15 minutes, while longer fragments (>3 kb) or complex templates can be extended at a speed of 10-30 s/kb or a higher number of cycles. The unique MasterMix formula makes the whole reaction system very stable, while complex templates can be amplified effectively, and more than 98% of PCR amplification can be successful in one run. Simply add the DNA template and primers and top up with water to minimize human error, contamination and time.The dye (blue) has been added to the product and it is ready for electrophoretic detection at the end of the reaction. The PCR product is amplified with an 'A' base at the 3′ end and can therefore be used directly for T/A cloning and is suitable for use in the CombiVerge Seamless Cloning Kit, T4 Ligation Kit and sensory products.This product is mainly suitable for ultra-fast PCR, complex templates, complex secondary structures, gene cloning and large-scale genetic testing that requires high fidelity. quality control No exogenous nuclease activity was detected; no host residual DNA was detected by PCR; single-copy genes in various genomes could be amplified efficiently. UsageThe following is an example of a PCR reaction system and reaction conditions for amplifying a 1 kb fragment using human genomic DNA as a template, which should be improved and optimized according to the template, primer structure and size of the target fragment in actual operation.PCR reaction system Note: Please use the final concentration of 0.1-1.0 µM as a reference for setting the range of primer concentration. If the amplification efficiency is not high, the primer concentration can be increased; if a non-specific reaction occurs, the primer concentration can be decreased to optimize the reaction system.PCR reaction conditions Note: 1) Note: For simple templates, the pre-denaturation time can be controlled at 30 s-1 min, for complex templates such as bacterial fluids, the pre-denaturation time can be increased to 2 min.Optimization of parameter settings 1. Template DNA amount setting:Excessive amounts of template may result in non-specific amplification or smear. The recommended amount of template DNA in a 50 µl PCR reaction system is as follows:-Human genomic DNA 5 ng-500 ng-Escherichia coli genomic DNA 50 pg-100 ng-plasmid DNA 10 pg-1 ng 1. 30-35 number of cycles2. Primer concentration setting: The primer concentration can be set between 0.1 µM and 1.0 µM. A low primer concentration may result in low amplification products. Too high a primer concentration will inhibit specific amplification and may result in non-specific amplification.3. Annealing temperature setting: In general, the annealing temperature is 5℃ lower than the melting temperature of amplification primer Tm, so the annealing temperature can be lowered appropriately when the desired amplification efficiency cannot be obtained; the annealing temperature can be raised appropriately when non-specific reaction occurs. For complex templates, it is necessary to adjust the annealing temperature to achieve efficient amplification.4. Extension time setting: The extension time should be set according to the size of the amplified fragments. The following extension times are recommended: simple templates such as plasmids: 5-15 s/kb; regular genomes, cDNA templates: 10-15 s/kb; complex templates, crude templates: 20-30 s/kb; (the extension time should not be too short and should be at least 5 s/kb, but should not exceed 30 s/kb).5. Number of cycles: The number of cycles can be set according to the downstream application of the amplified product. If the number of cycles is too low, the amount of amplification will be insufficient; if the number of cycles is too high, the chance of mismatch will increase and the non-specific background will be serious. Therefore, the number of cycles should be minimized under the premise of ensuring the product yield... Read More | Inquire | Purity:>95%, by SDS-PAGE visualized with Coomassie® Blue Staining.Description：CD200 R1, also known as OX-2 receptor, is a 90 kDa transmembrane protein in the immunoglobulin superfamily and is important in the regulation of myeloid cell activity. The human CD200 R1 cDNA encodes a 325 Purity:>95%, by SDS-PAGE visualized with Coomassie® Blue Staining.Description：CD200 R1, also known as OX-2 receptor, is a 90 kDa transmembrane protein in the immunoglobulin superfamily and is important in the regulation of myeloid cell activity. The human CD200 R1 cDNA encodes a 325 amino acid (aa) precursor that includes a 28 aa signal sequence, a 215 aa extracellular domain (ECD), a 21 aa transmembrane segment, and a 61 aa cytoplasmic domain. The ECD is composed of one Ig-like V-type domain and one Ig-like C2-type domain. Within the ECD, human CD200 R1 shares 56% aa sequence identity with both mouse and rat CD200 R1. Alternate splicing of the human CD200 R1 mRNA generates four isoforms, two of which are truncated in the Ig-C2 domain and are likely secreted. In human, a separate CD200 RL gene encodes a protein that shares 81% ECD aa identity with CD200 R1. In mouse, at least four genes for CD200 R1-like molecules have been described. CD200 R1 expression is restricted primarily to mast cells, basophils, macrophages, and dendritic cells, while its ligand, CD200, is widely distributed. Disruption of this receptor-ligand system by knockout of the CD200 gene in mice leads to increased macrophage number and activation and predisposition to autoimmune disorders. Association of CD200 with CD200 R1 takes place between their respective N-terminal Ig-like domains. The capacity of CD200 R1-like molecules to interact with CD200 is controversial. CD200 R1 propagates inhibitory signals despite lacking a cytoplasmic ITIM (immunoreceptor tyrosine-based inhibitory motif). CD200 R1-like molecules, in contrast, are potentially activating receptors by means of their association with DAP12. CD200R1 signaling inhibits the expression of proinflammatory molecules including TNFs, IFNs, and inducible nitric oxide synthase in response to selected stimuli, which implicate that CD200/CD200R1 inhibitory signaling pathway plays a prominent role in limiting inflammation in a wide range of inflammatory diseases. Furthermore, the CD200/CD200R inhibitory signaling constitutes one of the most suitable endogenous immunoregulatory molecule candidate to restore the immune suppressive status of the CNS altered in chronic neuroinflammatory situations... Read More | Inquire |