| Description | Enzymes extracted from mammalian testes (e.g., sheep testes) can hydrolyze mucopolysaccharides of the hyaluronic acid type. They may contain a suitable stabilizer. Potency: Minimum 3000 IU of hyaluronidase activity per milligram (of dry substance).ProductionAnimals used for producing hyaluronidase Enzymes extracted from mammalian testes (e.g., sheep testes) can hydrolyze mucopolysaccharides of the hyaluronic acid type. They may contain a suitable stabilizer. Potency: Minimum 3000 IU of hyaluronidase activity per milligram (of dry substance).ProductionAnimals used for producing hyaluronidase must meet the health requirements for animals intended for human consumption.Characteristics1.Appearance: White or yellowish-white, amorphous powder.2.Solubility: Soluble in water, almost insoluble in acetone and absolute ethanol.IdentificationA solution containing 100 IU of hyaluronidase in 1 mL of 9 g/L sodium chloride solution depolymerizes a 10 g/L sodium hyaluronate BRP solution at 20°C, resulting in a significant decrease in viscosity. Heating the hyaluronidase at 100°C for 30 minutes destroys this effect.Tests1.Appearance of Solution: The solution should be clear. Dissolve 0.10 g in water and dilute to 10 mL with the same solvent.2.pH: 4.5 to 7.5. Dissolve 30 mg in carbon dioxide-free water and dilute to 10 mL with the same solvent.3.Loss on Drying: Maximum 5.0%. Determine by drying 0.500 g at 60°C under a pressure not exceeding 670 Pa for 2 hours.4.Bacterial Endotoxins: ≤ 0.2 EU/IU.AssayThe activity of hyaluronidase is determined using a slope-ratio assay, by comparing the rate at which it hydrolyzes sodium hyaluronate BRP with the rate obtained using the International Standard or a reference preparation calibrated in International Units.Substrate SolutionIn a 25 mL conical flask, add 0.10 g of sodium hyaluronate BRP, then slowly add 20.0 mL of water at 4°C. The addition rate must be slow enough to allow the substrate particles to swell (approximately 5 minutes). Maintain at 4°C and stir for at least 12 hours. Store at 4°C and use within 4 days.For both the test solution and the reference solution, prepare the solutions and perform dilutions at 0°C to 4°C.1.Test Solution: Dissolve an appropriate amount of the substance in hyaluronidase diluent to obtain a solution containing 0.6 ± 0.3 IU of hyaluronidase per mL.2.Reference Solution: Dissolve an appropriate amount of hyaluronidase BRP in hyaluronidase diluent to obtain a solution containing 0.6 IU of hyaluronidase per mL.In a reaction vessel, mix 1.50 mL of phosphate buffer solution (pH 6.4) and 1.0 mL of the substrate solution, and equilibrate at 37 ± 0.1°C. At time t₀ = 0 (using the first timer), add 0.50 mL of the test solution containing E milligrams of the enzyme to be tested, mix well. Maintain the mixture at 37 ± 0.1°C using a suitable viscometer, record the flow time t using a second timer (with 0.1-second intervals), and perform multiple measurements over approximately 20 minutes (monitoring with the first timer). Use the following viscometer: microviscometer (DIN 51 562, Part 2), capillary type MII, with a viscometer constant of approximately 0.1 mm²/s².Repeat the above procedure using 0.50 mL of the reference solution containing hyaluronidase BRP. Calculate the viscosity ratio using the following expression:K = Viscometer constant (in mm²/s², indicated on the viscometer);t₂ = Flow time of the solution (in seconds);0.6915 = Kinematic viscosity of the buffer solution at 37°C (in mm²/s).Since the enzymatic reaction continues during the flow time measurement, the actual reaction time is equal to t₀ + t/2 (i.e., half of the flow time (t/2) is added to the initial measurement time t₀). Plot (ln η)⁻¹ as a function of the reaction time (t₀ + t/2) (in seconds); a linear relationship should be obtained. Calculate the slope (b) of the substance to be tested and the slope (bᵣ) of the reference preparation. Determine the specific activity in International Units per milligram using the following expression:A = Specific activity of hyaluronidase BRP (in International Units per milligram).Perform at least three complete sets of the procedure and calculate the average activity of the substance to be tested.StorageStore in a tightly closed container at a temperature of 2°C to 8°C. If the substance is sterile, the container should also be sterile and tamper-proof... Read More | Inquire | p53 and MDM2 proteins-interaction-inhibitor dihydrochloride is an inhibitor of the interaction between p53 and MDM2 proteins.Form:Solid | Purity:>90%, by SDS-PAGE visualized with Coomassie® Blue Staining.Description: DCX (doublecortin, N-GST chimera)contains 2 doublecortin domains and belongs to the doublecortin family. It is highly expressed in neuronal cells of fetal brain, but not expressed in other fetal tissues. In the Purity:>90%, by SDS-PAGE visualized with Coomassie® Blue Staining.Description: DCX (doublecortin, N-GST chimera)contains 2 doublecortin domains and belongs to the doublecortin family. It is highly expressed in neuronal cells of fetal brain, but not expressed in other fetal tissues. In the adult, it is highly expressed in the brain frontal lobe, but very low expression in other regions of brain, and not detected in heart, placenta, lung, liver, skeletal muscles, kidney and pancreas. DCX is a microtubule-associated protein required for initial steps of neuronal dispersion and cortex lamination during cerebral cortex development. It may act by competing with the putative neuronal protein kinase DCAMKL1 in binding to a target protein. DCX may in that way participate in a signaling pathway that is crucial for neuronal interaction before and during migration, possibly as part of a calcium ion-dependent signal transduction pathway. It may be part with LIS-1 of a overlapping, but distinct, signaling pathways that promote neuronal migration. Defects in DCX are the cause of lissencephaly X-linked type 1 and subcortical band heterotopia X-linked... Read More | Purity:>95%, by SDS-PAGE visualized with Coomassie® Blue Staining.Description:Monkeypox is a zoonotic disease caused by monkeypox virus (MPXV), which is a member of orthopoxvirus genus. A35R gene is highly conserved among poxviruses and encodes a previously uncharacterized hydrophobic acidicPurity:>95%, by SDS-PAGE visualized with Coomassie® Blue Staining.Description:Monkeypox is a zoonotic disease caused by monkeypox virus (MPXV), which is a member of orthopoxvirus genus. A35R gene is highly conserved among poxviruses and encodes a previously uncharacterized hydrophobic acidic protein. The A35R has little homology to any protein outside of poxviruses, suggesting a novel virulence Monkeypox is a zoonotic disease caused by monkeypox virus (MPXV), which is a member of orthopoxvirus genus. A35R gene is highly conserved among poxviruses and encodes a previously uncharacterized hydrophobic acidic protein. The A35R has little homology to any protein outside of poxviruses, suggesting a novel virulence mechanism.A35R could block some stage of antigen processing or presentation in infected cells or interfere with regulation of apoptosis. In addition, the A35R function may be required for growth in certain cell types, e.g., macrophage, in vivo. It localizes to factories where viral DNA is located and it was shown to be a constitutive transcriptional activator in a large-scale yeast two-hybrid study... Read More |