| Description | γ-Secretase modulator 4 is a potent γ-secretase modulator, reduces the Aβ42 level with IC 50 s of 0.014 µM and 0.017 µM in human and mouse, respectively | Product Content:F665667Component5 mL40 mLStorageF665667A2×Flash PCR MasterMix (Dye) 5×1 mL 40×1 mL-20℃. Avoid freeze/thaw cycle.F665667BddH2O 5×1 mL40×1 mL-20℃. Avoid freeze/thaw cycle. Products Introduction This product is a premixed system consisting of a new Product Content:F665667Component5 mL40 mLStorageF665667A2×Flash PCR MasterMix (Dye) 5×1 mL 40×1 mL-20℃. Avoid freeze/thaw cycle.F665667BddH2O 5×1 mL40×1 mL-20℃. Avoid freeze/thaw cycle. Products Introduction This product is a premixed system consisting of a new high efficient fast DNA Polymerase, Mg2+, dNTPs, and PCR stabilizers and enhancers at 2× concentration. It is a new rapid DNA polymerase developed by CombiSigma with high amplification speed and stability. The extension speed is up to 5 s/kb, and the PCR can be completed in as little as 15 minutes, while longer fragments (>3 kb) or complex templates can be extended at a speed of 10-30 s/kb or a higher number of cycles. The unique MasterMix formula makes the whole reaction system very stable, while complex templates can be amplified effectively, and more than 98% of PCR amplification can be successful in one run. Simply add the DNA template and primers and top up with water to minimize human error, contamination and time.The dye (blue) has been added to the product and it is ready for electrophoretic detection at the end of the reaction. The PCR product is amplified with an 'A' base at the 3′ end and can therefore be used directly for T/A cloning and is suitable for use in the CombiVerge Seamless Cloning Kit, T4 Ligation Kit and sensory products.This product is mainly suitable for ultra-fast PCR, complex templates, complex secondary structures, gene cloning and large-scale genetic testing that requires high fidelity. quality control No exogenous nuclease activity was detected; no host residual DNA was detected by PCR; single-copy genes in various genomes could be amplified efficiently. UsageThe following is an example of a PCR reaction system and reaction conditions for amplifying a 1 kb fragment using human genomic DNA as a template, which should be improved and optimized according to the template, primer structure and size of the target fragment in actual operation.PCR reaction system Note: Please use the final concentration of 0.1-1.0 µM as a reference for setting the range of primer concentration. If the amplification efficiency is not high, the primer concentration can be increased; if a non-specific reaction occurs, the primer concentration can be decreased to optimize the reaction system.PCR reaction conditions Note: 1) Note: For simple templates, the pre-denaturation time can be controlled at 30 s-1 min, for complex templates such as bacterial fluids, the pre-denaturation time can be increased to 2 min.Optimization of parameter settings 1. Template DNA amount setting:Excessive amounts of template may result in non-specific amplification or smear. The recommended amount of template DNA in a 50 µl PCR reaction system is as follows:-Human genomic DNA 5 ng-500 ng-Escherichia coli genomic DNA 50 pg-100 ng-plasmid DNA 10 pg-1 ng 1. 30-35 number of cycles2. Primer concentration setting: The primer concentration can be set between 0.1 µM and 1.0 µM. A low primer concentration may result in low amplification products. Too high a primer concentration will inhibit specific amplification and may result in non-specific amplification.3. Annealing temperature setting: In general, the annealing temperature is 5℃ lower than the melting temperature of amplification primer Tm, so the annealing temperature can be lowered appropriately when the desired amplification efficiency cannot be obtained; the annealing temperature can be raised appropriately when non-specific reaction occurs. For complex templates, it is necessary to adjust the annealing temperature to achieve efficient amplification.4. Extension time setting: The extension time should be set according to the size of the amplified fragments. The following extension times are recommended: simple templates such as plasmids: 5-15 s/kb; regular genomes, cDNA templates: 10-15 s/kb; complex templates, crude templates: 20-30 s/kb; (the extension time should not be too short and should be at least 5 s/kb, but should not exceed 30 s/kb).5. Number of cycles: The number of cycles can be set according to the downstream application of the amplified product. If the number of cycles is too low, the amount of amplification will be insufficient; if the number of cycles is too high, the chance of mismatch will increase and the non-specific background will be serious. Therefore, the number of cycles should be minimized under the premise of ensuring the product yield... Read More | Protein Purity>90 % by SDS PAGEExtinction CoeffA280 nm = 0.725 at 1.0 mg/mL for pure C1s-C1INH ComplexMolecular Weight196,000 Da (1 chain)General DescriptionThe product C1s-C1INH Complex is made by interacting purified protease inhibitor C1-INH with purified C1s enzyme followed by purification. Protein Purity>90 % by SDS PAGEExtinction CoeffA280 nm = 0.725 at 1.0 mg/mL for pure C1s-C1INH ComplexMolecular Weight196,000 Da (1 chain)General DescriptionThe product C1s-C1INH Complex is made by interacting purified protease inhibitor C1-INH with purified C1s enzyme followed by purification. The protease inhibitor C1-INH prevents the spontaneous activation of complement and limits consumption of C2 and C4 by rapidly inactivating C1r, C1s and MASP2. It is the only plasma serine protease inhibitor (Serpin) capable of interacting with and inhibiting activated C1. C1-INH interacts with the catalytic sites of both C1r and C1s. The interaction with activated C1r and C1s is covalent resulting in complexes which are stable to SDS. C1s and C1r enzymes, however, are irreversibly inactivated by binding to C1-INH. C1s-C1INH is a very stable complex that remains intact even when subjected to freeze/thaw cycles with almost no loss of the complex form.Physical Characteristics & StructureThe C1s enzyme-C1INH complex is composed of two disulfide linked chains from C1s enzyme (A chain 58,000 Da and B chain 28,000 Da) and one covalently linked chain from C1-INH (75,000 Da).SDS-PAGE analysis of the C1s-C1INH complex shows a single band of about 161,000 Da under nonreducing conditions. Under reducing conditions, the C1s-C1INH complex exhibits two bands: A 58,000 Da band corresponding to the A chain of C1s enzyme and a second 103,000 Da band resulting from C1INH (75,000 Da) covalently bond to the B chain (28,000 Da) of C1s enzyme.RegulationActivated C1s is controlled by C1-INH. C1s enzyme and C1-INH form a covalent complex that is resistant to separation on SDS gels. During complement activation C1 complex is rapidly activated by binding to immune complexes. The resulting activated C1s and C1r are rapidly inactivated by interaction with C1-INH (Ziccardi, R.J. (1982)). Binding to immune complexes is fast (10-20 sec) and activation of the bound C1 complex takes several minutes, but C1-INH has also been shown to be fast and no active C1r or C1s remain 4 min after addition of immune complexes to plasma (Ross, G.D. (1986); Ziccardi,R.J. (1981)). The binding of C1-INH to activated C1 releases both C1r and C1s from the complex leaving C1q bound to the immune complex. The released complexes contain four molecules: C1-INH-C1r-C1s-C1-INH. The reaction of C1 esterase inhibitor with activated C1 is very fast with the estimated half-life of C1r and C1s being approximately 15 seconds in serum. In fact, at serum concentrations of C1- INH little or no additional C4 or C2 activation occurs 3 min after immune complexes are added because all the C1r and C1s molecules have been inactivated and removed from the C1q which remains bound to the immune complex (Ross, G.D. (1986); Morley, B.J. and Walport, M.J. (2000); Rother, K., et al. (1998); Ziccardi, R.J. (1982a and 1982b); Morgan, B.P. (1990)). The interaction of purified C1s enzyme and C1-INH is slower.FunctionSee General Description and Regulation above.ApplicationsC1s-C1INH complex can be used in studies designed for developing and identifying inhibitors of C1s-C1INH complex formation and thus lead to the possible development of therapeutics for inhibiting complement activation via the classical pathway.GeneticsThe EMBL/Genbank cDNA accession number for C1s is J04080. The gene for C1s is located on chromosome 12p13. The EMBL/Genbank cDNA accession numbers for C1-INH are M13656 and X54486 (human) and Y10386 (mouse). The gene for C1-INH is located on chromosome 11p11.2-13. DeficienciesC1s deficient patients are prone to systemic lupus erythematosus (SLE) and recurrent pyogenic infections (Rother, K., et al. (1998)). They lack classical pathway function. The genetic disorder hereditary angioedema (HAE) is caused by a partial deficiency of C1-INH. Patients with HAE have low functional C1-INH levels in blood and have recurrent episodes of systemic or localized edema.DiseasesSee section titled Deficiencies above. Precautions/Toxicity/HazardsThis protein is purified from human serum and therefore precautions appropriate for handling any blood-derived product must be used even though the source was shown by certified tests to be negative for HBsAg, HTLV-I/II, STS, and for antibodies to HCV, HIV-1 and HIV-II.ReferencesZiccardi, RJ. (1982) A new role for C-1-inhibitor in homeostasis: control of activation of the first component of human complement. J. Immunol. 128:2505-2508.Ross, G.D. (1986) Immunobiology of the Complement System. (ISBN 0-12-5976402) Academic Press, Orlando.Ziccardi, R.J. (1981) Activation of the early components of the classical complement pathway under physiologic conditions. J. Immunol. 126:1769-1773.Morley, B.J. and Walport, M.J. (2000) The Complement Facts Book. (ISBN 0127333606) Academic Press, London.Rother, K., Till, G.O., and Hӓnsch, G.M. (1998) The Complement System. (ISBN 3-540- 61894-5) Springer-Verlag, Heidelberg.Ziccardi, R.J. (1982a) Spontaneous activation of the first component of human complement (C1) by an intramolecular autocatalytic mechanism. J. Immunol. 128:2500- 2504.Ziccardi, RJ. (1982b) A new role for C-1-inhibitor in homeostasis: control of activation of the first component of human complement. J. Immunol. 128:2505-2508. Morgan, B.P. (1990) Complement Clinical Aspects and Relevance to Disease. (ISBN 0- 12-506955-3) Academic Press, London... Read More | Laccase is an enzyme, produced by ericoid mycorrhiza and ectomycorrhiza fungi. It belongs to the group of polyphenol oxidases. Laccase is also present in plants and bacteria.Laccase from Trametes versicolor has been used: to assess the use of four laccase-producing strains in waste water treatment Laccase is an enzyme, produced by ericoid mycorrhiza and ectomycorrhiza fungi. It belongs to the group of polyphenol oxidases. Laccase is also present in plants and bacteria.Laccase from Trametes versicolor has been used: to assess the use of four laccase-producing strains in waste water treatment in laccase assay in screening the lignolsSome of the enzymatic actions of laccase are associated with sporulation, detoxification, morphogenesis, melanin polymerization and it offers protection to spore coat. Laccase can catalyse a number of substrates including medicinal drugs and halogenated pesticides. It utilizes oxygen for its catalysis. For these reasons, it might be useful in the biological degradation of micropollutants in wastewater treatment. Laccase catalyzes the oxidation of phenol containing compounds, including lignin, through the reduction of oxygen to water. The presence of mediators will allow the oxidation of non-phenlic compounds as well. The primary function of laccase is to degrade lignin in fungi... Read More | PTD-p65-P1 Peptide TFA is a potent, selective nuclear transcription factor NF-κB inhibitor and derives from the p65 subunit of NF-κB amino acid residues 271-282, which selectively inhibits NF-κB activation induced by various inflammatory stimulation, downAppearance:SolidIC50& PTD-p65-P1 Peptide TFA is a potent, selective nuclear transcription factor NF-κB inhibitor and derives from the p65 subunit of NF-κB amino acid residues 271-282, which selectively inhibits NF-κB activation induced by various inflammatory stimulation, downAppearance:SolidIC50& Target:NF-kappaBIn Vitro:PTD-p65-P1 Peptide TFA (10-150 µM; 0-60 min; KBM-5 cells) inhibits TNF-induced NF-κB activation in a dose-dependent manner and suppresses TNF-induced NF-κB activation by 25% at 100 µM and completely at 150 µM. PTD-p65-P1 Peptide TFA (150 µM; 0-60 minBiological Activity:PTD-p65-P1 Peptide TFA is a potent, selective nuclear transcription factor NF-κB inhibitor and derives from the p65 subunit of NF-κB amino acid residues 271-282, which selectively inhibits NF-κB activation induced by various inflammatory stimulation, down... Read More |