| Description | GPRIN2 Human Pre-designed siRNA Set A contains three designed siRNAs for GPRIN2 gene (Human), as well as a negative control, a positive control, and a FAM-labeled negative control. Components GPRIN2 siRNA-1: 5 nmol (HPLC) GPRIN2 siRNA-2: 5 nmol (HPLC) GPRIN2 siRNA-3: 5 nmol (HPLC) siRNA Negative GPRIN2 Human Pre-designed siRNA Set A contains three designed siRNAs for GPRIN2 gene (Human), as well as a negative control, a positive control, and a FAM-labeled negative control. Components GPRIN2 siRNA-1: 5 nmol (HPLC) GPRIN2 siRNA-2: 5 nmol (HPLC) GPRIN2 siRNA-3: 5 nmol (HPLC) siRNA Negative Control: 5 nmol (HPLC) FAM-labeled siRNA Negative Control: 5 nmol (HPLC) GAPDH siRNA Positive Control:5 nmol (HPLC)... Read More | Product Content:F665667Component5 mL40 mLStorageF665667A2×Flash PCR MasterMix (Dye) 5×1 mL 40×1 mL-20℃. Avoid freeze/thaw cycle.F665667BddH2O 5×1 mL40×1 mL-20℃. Avoid freeze/thaw cycle. Products Introduction This product is a premixed system consisting of a new Product Content:F665667Component5 mL40 mLStorageF665667A2×Flash PCR MasterMix (Dye) 5×1 mL 40×1 mL-20℃. Avoid freeze/thaw cycle.F665667BddH2O 5×1 mL40×1 mL-20℃. Avoid freeze/thaw cycle. Products Introduction This product is a premixed system consisting of a new high efficient fast DNA Polymerase, Mg2+, dNTPs, and PCR stabilizers and enhancers at 2× concentration. It is a new rapid DNA polymerase developed by CombiSigma with high amplification speed and stability. The extension speed is up to 5 s/kb, and the PCR can be completed in as little as 15 minutes, while longer fragments (>3 kb) or complex templates can be extended at a speed of 10-30 s/kb or a higher number of cycles. The unique MasterMix formula makes the whole reaction system very stable, while complex templates can be amplified effectively, and more than 98% of PCR amplification can be successful in one run. Simply add the DNA template and primers and top up with water to minimize human error, contamination and time.The dye (blue) has been added to the product and it is ready for electrophoretic detection at the end of the reaction. The PCR product is amplified with an 'A' base at the 3′ end and can therefore be used directly for T/A cloning and is suitable for use in the CombiVerge Seamless Cloning Kit, T4 Ligation Kit and sensory products.This product is mainly suitable for ultra-fast PCR, complex templates, complex secondary structures, gene cloning and large-scale genetic testing that requires high fidelity. quality control No exogenous nuclease activity was detected; no host residual DNA was detected by PCR; single-copy genes in various genomes could be amplified efficiently. UsageThe following is an example of a PCR reaction system and reaction conditions for amplifying a 1 kb fragment using human genomic DNA as a template, which should be improved and optimized according to the template, primer structure and size of the target fragment in actual operation.PCR reaction system Note: Please use the final concentration of 0.1-1.0 µM as a reference for setting the range of primer concentration. If the amplification efficiency is not high, the primer concentration can be increased; if a non-specific reaction occurs, the primer concentration can be decreased to optimize the reaction system.PCR reaction conditions Note: 1) Note: For simple templates, the pre-denaturation time can be controlled at 30 s-1 min, for complex templates such as bacterial fluids, the pre-denaturation time can be increased to 2 min.Optimization of parameter settings 1. Template DNA amount setting:Excessive amounts of template may result in non-specific amplification or smear. The recommended amount of template DNA in a 50 µl PCR reaction system is as follows:-Human genomic DNA 5 ng-500 ng-Escherichia coli genomic DNA 50 pg-100 ng-plasmid DNA 10 pg-1 ng 1. 30-35 number of cycles2. Primer concentration setting: The primer concentration can be set between 0.1 µM and 1.0 µM. A low primer concentration may result in low amplification products. Too high a primer concentration will inhibit specific amplification and may result in non-specific amplification.3. Annealing temperature setting: In general, the annealing temperature is 5℃ lower than the melting temperature of amplification primer Tm, so the annealing temperature can be lowered appropriately when the desired amplification efficiency cannot be obtained; the annealing temperature can be raised appropriately when non-specific reaction occurs. For complex templates, it is necessary to adjust the annealing temperature to achieve efficient amplification.4. Extension time setting: The extension time should be set according to the size of the amplified fragments. The following extension times are recommended: simple templates such as plasmids: 5-15 s/kb; regular genomes, cDNA templates: 10-15 s/kb; complex templates, crude templates: 20-30 s/kb; (the extension time should not be too short and should be at least 5 s/kb, but should not exceed 30 s/kb).5. Number of cycles: The number of cycles can be set according to the downstream application of the amplified product. If the number of cycles is too low, the amount of amplification will be insufficient; if the number of cycles is too high, the chance of mismatch will increase and the non-specific background will be serious. Therefore, the number of cycles should be minimized under the premise of ensuring the product yield... Read More | Extinction Coeff.A280 nm = 1.0 at 1.0 mg/mLSpecificityMonospecific for Factor B in human plasma and serumGeneral DescriptionProduct is whole polyclonal antiserum from goats immunized with highly purified human complement protein. Product is not a purified IgG fraction. Goats are maintained in FDA Extinction Coeff.A280 nm = 1.0 at 1.0 mg/mLSpecificityMonospecific for Factor B in human plasma and serumGeneral DescriptionProduct is whole polyclonal antiserum from goats immunized with highly purified human complement protein. Product is not a purified IgG fraction. Goats are maintained in FDA certified facilities.Physical Characteristics & StructureAntibodies present in the antisera are primarily IgGApplicationsWestern Blots: Effective at dilutions 1/4,000 to 1/8,000 depending on conditions.Most effective against non-reduced antigen.ELISA: Effective at dilutions 1/8,000 to 1/16,000 depending on conditions.Immunodiffusion: Effective against NHS and plasma at 1/16 dilution... Read More | Inorganic pyrophosphates are inevitably produced in the process of mRNA transcription in vitro. These substances have a great inhibitory effect on transcription. Inorganic pyrophosphatase (PPase) can hydrolyze the inorganic pyrophosphates produced in nucleic acid amplification experiments, promote Inorganic pyrophosphates are inevitably produced in the process of mRNA transcription in vitro. These substances have a great inhibitory effect on transcription. Inorganic pyrophosphatase (PPase) can hydrolyze the inorganic pyrophosphates produced in nucleic acid amplification experiments, promote the shift of reaction equilibrium to the product generation end, and increase the amount of products.The molecular weight of PPase (pyrophosphatase, inorganic, inorganic pyrophosphatase) is about 63kd, which can catalyze the hydrolysis of inorganic pyrophosphate to produce orthophosphate: P2O74_+H2O+PPase→2HPO42_. In the nucleic acid amplification experiment, PPase can hydrolyze the inorganic pyrophosphate generated with the reaction to avoid its inhibition on the reaction system. The removal of pyrophosphate can shift the reaction equilibrium to the product generation end.This product is a GMP level recombinant inorganic pyrophosphatase (yeast source) expressed by large-scale fermentation of E. coli. It is produced with raw and auxiliary materials of medicinal specifications, and the host protein residue and nucleic acid residue are strictly controlled. The product production and quality management procedures in line with GMP specifications ensure that the production process and all raw and auxiliary materials can be traced.Quality requirements project standard appearance Clear liquid Visible foreign matter Compliance with regulations PH value 7.5±8.5 activity 98U/ml-102U/ml purity ≥95% Endonuclease residues Degradation of substrate shall not exceed 10% Exonuclease residues Degradation of substrate shall not exceed 10% RNase residue Degradation of substrate shall not exceed 10% Bacterial endotoxin content ≤10EU/ml Exogenous DNA residue ≤100pg/mg Host protein residue ≤50ppm Mycoplasma detection negative Heavy metal residues ≤10ppm Follow the following specifications1. ISO 9001:2015, certified facility。2. GMP appendix - cell therapy products State Drug Administration.3. general introduction to human gene therapy - Chinese Pharmacopoeia 2020, National Pharmacopoeia Committee.4. USP chapter <1043>, adjuvant materials for cell, gene, and tissue engineered products.5. USP chapter <92>, growth factors and cytokines used in cell therapy manufacturing.6. Ph. Eur. General chapter 5.2.12, raw materials of biological origin for the production of cell-based and gene therapy medical products.Product features1. hydrolyze inorganic pyrophosphate.2. DNA synthesis: significantly enhance DNA replication ability.3. RNA synthesis: increase RNA production in in vitro transcription reaction.4. The optimal reaction temperature is 25℃, and the enzyme can be inactivated at 65℃ for 10min.Product usage1. optimize RNA transcription: improve the RNA yield of in vitro transcription reaction.2. remove PPI contamination from reagents for SNP genotyping by pyrophosphate assay.3. promote the synthesis of protein, RNA and DNA.4. catalyze the reaction of PPI + H2O → 2pi.5. ssr-pcr optimization：Improve efficiency and increase DNA production.Activity definitionCatalytic inorganic pyrophosphate formation 1 per minute under standard reaction conditions µ The amount of enzyme required for mol phosphate was defined as 1 active unit.Preservation system20 mM Tris-HCl; 100 mM NaCl; 1 mM DTT; 0.1 mM EDTA; 50% (v/v) Glycerol; pH 8.0。 Storage temperature-20±5 ℃。Matters needing attention1. the enzyme has activity in various reaction buffers. Generally, the enzyme can be directly added in HDA, lamp and other experiments.2. the dosage of the enzyme needs to be optimized in different experiments, usually adjusted at the concentration of 0.05~1u/ml.3. the optimum reaction temperature of the enzyme was 25 ℃, and it was active at 16~37 ℃, and the enzyme could be inactivated at 65 ℃ for 10min.4. cofactor: mg2+ is necessary for enzyme activity... Read More | Purity>95% SDS-PAGE.FunctionImportant adipokine involved in the control of fat metabolism and insulin sensitivity, with direct anti-diabetic, anti-atherogenic and anti-inflammatory activities. Stimulates AMPK phosphorylation and activation in the liver and the skeletal muscle, enhancing glucose Purity>95% SDS-PAGE.FunctionImportant adipokine involved in the control of fat metabolism and insulin sensitivity, with direct anti-diabetic, anti-atherogenic and anti-inflammatory activities. Stimulates AMPK phosphorylation and activation in the liver and the skeletal muscle, enhancing glucose utilization and fatty-acid combustion. Antagonizes TNF-alpha by negatively regulating its expression in various tissues such as liver and macrophages, and also by counteracting its effects. Inhibits endothelial NF-kappa-B signaling through a cAMP-dependent pathway. May play a role in cell growth, angiogenesis and tissue remodeling by binding and sequestering various growth factors with distinct binding affinities, depending on the type of complex, LMW, MMW or HMW.Post-translationalHydroxylated Lys-33 was not identified in PubMed:16497731, probably due to poor representation of the N-terminal peptide in mass fingerprinting. HMW complexes are more extensively glycosylated than smaller oligomers. Hydroxylation and glycosylation of the lysine residues within the collagene-like domain of adiponectin seem to be critically involved in regulating the formation and/or secretion of HMW complexes and consequently contribute to the insulin-sensitizing activity of adiponectin in hepatocytes. O-glycosylated. Not N-glycosylated. O-linked glycans on hydroxylysines consist of Glc-Gal disaccharides bound to the oxygen atom of post-translationally added hydroxyl groups. Sialylated to varying degrees depending on tissue. Thr-22 appears to be the major site of sialylation. Higher sialylation found in SGBS adipocytes than in HEK fibroblasts. Sialylation is not required neither for heterodimerization nor for secretion. Not sialylated on the glycosylated hydroxylysines. Desialylated forms are rapidly cleared from the circulation... Read More |