| Description | EIF4E3 Human Pre-designed siRNA Set A contains three designed siRNAs for EIF4E3 gene (Human), as well as a negative control, a positive control, and a FAM-labeled negative control. Components EIF4E3 siRNA-1: 5 nmol (HPLC) EIF4E3 siRNA-2: 5 nmol (HPLC) EIF4E3 siRNA-3: 5 nmol (HPLC) siRNA Negative EIF4E3 Human Pre-designed siRNA Set A contains three designed siRNAs for EIF4E3 gene (Human), as well as a negative control, a positive control, and a FAM-labeled negative control. Components EIF4E3 siRNA-1: 5 nmol (HPLC) EIF4E3 siRNA-2: 5 nmol (HPLC) EIF4E3 siRNA-3: 5 nmol (HPLC) siRNA Negative Control: 5 nmol (HPLC) FAM-labeled siRNA Negative Control: 5 nmol (HPLC) GAPDH siRNA Positive Control:5 nmol (HPLC)... Read More | Product contentG665787Component5 mLStorageG665787A2×GoldStar Probe Mixture (UNG)5×1 mL-20℃. Avoid freeze/thaw cycle.G665787B50×High ROX200 µL-20℃. Avoid freeze/thaw cycle.G665787CddH2O 5×1 mL -20℃. Avoid freeze/thaw cycle. Product Introduction2× Product contentG665787Component5 mLStorageG665787A2×GoldStar Probe Mixture (UNG)5×1 mL-20℃. Avoid freeze/thaw cycle.G665787B50×High ROX200 µL-20℃. Avoid freeze/thaw cycle.G665787CddH2O 5×1 mL -20℃. Avoid freeze/thaw cycle. Product Introduction2× GoldStar Probe Mixture (UNG) is a premixed system dedicated to real-time fluorescence quantitative PCR by probe method (TaqMan, Molecular Beacon, etc.), with a concentration of 2×, containing GoldStar Taq DNA polymerase, PCR Buffer, dNTPs (dTTP is all replaced by dUTP), UNG enzyme and Mg2+, which is easy and convenient to operate. It is mainly used for the detection of genomic DNA target sequences and cDNA target sequences after RNA reverse transcription, such as gene expression analysis, copy number analysis and SNP genotype analysis. This product utilizes the dUTP-UNG anti-pollution system, which adds dUTP during the preparation of the PCR reaction system, thus forming an amplification product containing dU bases. This product can be eliminated by the UNG enzyme in the PCR system before the next PCR reaction. This effectively removes residual contamination of the PCR product and greatly reduces false positives due to contamination of the amplification product.UNG enzyme can be inactivated at the pre-denaturation step in the PCR cycle, and therefore will not affect the formation of new PCR products containing dU bases. The GoldStar Taq DNA Polymerase contained in this product is a chemically modified, new high-efficiency hot-start enzyme, which has no polymerase activity at room temperature, effectively avoiding non-specific amplification due to non-specific binding of primers and templates or primer dimerization at room temperature, and the activation of the enzyme must be incubated at 95°C for 10 minutes. The unique combination of PCR buffer system and hot-start enzyme significantly improves the amplification efficiency of PCR with stronger fluorescent signal and higher sensitivity to detect single-copy templates. A wider linear range and more accurate quantification of the target gene can be obtained by using this product.ROX dye is used to correct the fluorescence signal error generated between wells of a quantitative PCR instrument, and is generally used in Real Time PCR amplifiers from ABI, Stratagene, and other companies. The excitation optics vary from instrument to instrument, so the concentration of ROX dye must be matched to the corresponding fluorescence quantitative PCR instrument.Instruments that do not require ROX calibration (G670150):Roche LightCycler 480, Roche LightCyler 96, Bio-rad iCyler iQ, iQ5, CFX96 and others.Instruments requiring Low ROX calibration(G665780):ABI Prism7500/7500 Fast, QuantStudio®3 System, QuantStudio®5 System, QuantStudio®6 Flex System, QuantStudio®7 Flex System, ViiA 7 system. Stratagene Mx3000/Mx3005P, Corbett Rotor Gene 3000, and more.Instruments requiring High ROX calibration(G665787):ABI Prism 7000/7300/7700/7900, Eppendorf, ABI Step One/Step One Plus, and others.matters needing attentionBefore use, please mix gently by turning up and down, avoid foaming as much as possible, and use after brief centrifugation.Avoid repeated freezing and thawing of this product, repeated freezing and thawing may degrade the product performance. This product can be stored for long term at -20℃, protected from light. If frequent use is required within a short period of time, it can be stored at 2-8℃.UsageThe following examples are conventional PCR reaction systems and reaction conditions, which should be improved and optimized according to the template, primer structure and target fragment size in actual operation.1.PCR reaction systemReagents50 µl Reaction systemfinal concentration2×GoldStar Probe Mixture（UNG）25 µl1×Forward Primer，10 µM1 µl0.2 µM¹⁾Reverse Primer，10 µM1 µl0.2 µM¹⁾Probe，10 µM1 µl0.2 µM²⁾Template DNA2 µl³⁾ 50×Low ROX or High ROX（optional）⁴⁾1 µl1×ddH₂Oup to 50 µlNote: 1) Usually, better results can be obtained with a primer concentration of 0.2 µM, and 0.1-1.0 µM can be used as a reference for setting the range.(2) The concentration of the probe used is related to the fluorescence quantitative PCR instrument used, the type of probe, and the type of fluorescent labeling substance, please refer to the instrument manual or the specific requirements for the use of each fluorescent probe for the adjustment of the concentration in actual use.(3) Usually the amount of DNA template is 10-100ng genomic DNA or 1-10ng cDNA as a reference. Since the templates of different species contain different copy numbers of target genes, the templates can be subjected to gradient dilution to determine the optimal amount of template to be used.(4) The excitation optical system varies from instrument to instrument, choose to add 50×Low ROX or 50×High ROX according to the instrument using fluorescence quantification.2.PCR reaction programCaution! The pre-denaturation reaction of this product must be completed at 95°C for 10 minutes!Two-step PCR:Note: 1) The hot-start enzyme used in this product must be activated under the condition of pre-denaturation 95℃, 10min. 2) It is recommended to use two-step PCR reaction program, if you can't get good experimental results due to the use of primers with lower Tm value, etc., you can try to carry out three-step PCR amplification.Three-step PCR:... Read More | Laccase is an enzyme, produced by ericoid mycorrhiza and ectomycorrhiza fungi. It belongs to the group of polyphenol oxidases. Laccase is also present in plants and bacteria.Laccase from Trametes versicolor has been used: to assess the use of four laccase-producing strains in waste water treatment Laccase is an enzyme, produced by ericoid mycorrhiza and ectomycorrhiza fungi. It belongs to the group of polyphenol oxidases. Laccase is also present in plants and bacteria.Laccase from Trametes versicolor has been used: to assess the use of four laccase-producing strains in waste water treatment in laccase assay in screening the lignolsSome of the enzymatic actions of laccase are associated with sporulation, detoxification, morphogenesis, melanin polymerization and it offers protection to spore coat. Laccase can catalyse a number of substrates including medicinal drugs and halogenated pesticides. It utilizes oxygen for its catalysis. For these reasons, it might be useful in the biological degradation of micropollutants in wastewater treatment. Laccase catalyzes the oxidation of phenol containing compounds, including lignin, through the reduction of oxygen to water. The presence of mediators will allow the oxidation of non-phenlic compounds as well. The primary function of laccase is to degrade lignin in fungi... Read More | Inquire | Inorganic pyrophosphates are inevitably produced in the process of mRNA transcription in vitro. These substances have a great inhibitory effect on transcription. Inorganic pyrophosphatase (PPase) can hydrolyze the inorganic pyrophosphates produced in nucleic acid amplification experiments, promote Inorganic pyrophosphates are inevitably produced in the process of mRNA transcription in vitro. These substances have a great inhibitory effect on transcription. Inorganic pyrophosphatase (PPase) can hydrolyze the inorganic pyrophosphates produced in nucleic acid amplification experiments, promote the shift of reaction equilibrium to the product generation end, and increase the amount of products.The molecular weight of PPase (pyrophosphatase, inorganic, inorganic pyrophosphatase) is about 63kd, which can catalyze the hydrolysis of inorganic pyrophosphate to produce orthophosphate: P2O74_+H2O+PPase→2HPO42_. In the nucleic acid amplification experiment, PPase can hydrolyze the inorganic pyrophosphate generated with the reaction to avoid its inhibition on the reaction system. The removal of pyrophosphate can shift the reaction equilibrium to the product generation end.This product is a GMP level recombinant inorganic pyrophosphatase (yeast source) expressed by large-scale fermentation of E. coli. It is produced with raw and auxiliary materials of medicinal specifications, and the host protein residue and nucleic acid residue are strictly controlled. The product production and quality management procedures in line with GMP specifications ensure that the production process and all raw and auxiliary materials can be traced.Quality requirements project standard appearance Clear liquid Visible foreign matter Compliance with regulations PH value 7.5±8.5 activity 98U/ml-102U/ml purity ≥95% Endonuclease residues Degradation of substrate shall not exceed 10% Exonuclease residues Degradation of substrate shall not exceed 10% RNase residue Degradation of substrate shall not exceed 10% Bacterial endotoxin content ≤10EU/ml Exogenous DNA residue ≤100pg/mg Host protein residue ≤50ppm Mycoplasma detection negative Heavy metal residues ≤10ppm Follow the following specifications1. ISO 9001:2015, certified facility。2. GMP appendix - cell therapy products State Drug Administration.3. general introduction to human gene therapy - Chinese Pharmacopoeia 2020, National Pharmacopoeia Committee.4. USP chapter <1043>, adjuvant materials for cell, gene, and tissue engineered products.5. USP chapter <92>, growth factors and cytokines used in cell therapy manufacturing.6. Ph. Eur. General chapter 5.2.12, raw materials of biological origin for the production of cell-based and gene therapy medical products.Product features1. hydrolyze inorganic pyrophosphate.2. DNA synthesis: significantly enhance DNA replication ability.3. RNA synthesis: increase RNA production in in vitro transcription reaction.4. The optimal reaction temperature is 25℃, and the enzyme can be inactivated at 65℃ for 10min.Product usage1. optimize RNA transcription: improve the RNA yield of in vitro transcription reaction.2. remove PPI contamination from reagents for SNP genotyping by pyrophosphate assay.3. promote the synthesis of protein, RNA and DNA.4. catalyze the reaction of PPI + H2O → 2pi.5. ssr-pcr optimization：Improve efficiency and increase DNA production.Activity definitionCatalytic inorganic pyrophosphate formation 1 per minute under standard reaction conditions µ The amount of enzyme required for mol phosphate was defined as 1 active unit.Preservation system20 mM Tris-HCl; 100 mM NaCl; 1 mM DTT; 0.1 mM EDTA; 50% (v/v) Glycerol; pH 8.0。 Storage temperature-20±5 ℃。Matters needing attention1. the enzyme has activity in various reaction buffers. Generally, the enzyme can be directly added in HDA, lamp and other experiments.2. the dosage of the enzyme needs to be optimized in different experiments, usually adjusted at the concentration of 0.05~1u/ml.3. the optimum reaction temperature of the enzyme was 25 ℃, and it was active at 16~37 ℃, and the enzyme could be inactivated at 65 ℃ for 10min.4. cofactor: mg2+ is necessary for enzyme activity... Read More |